Manual Festool SRM 312 LE-AS (page 9 of 54) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

499198

Zoom out

Zoom in

1/54

4.1 Vacuuming dry materials

Before using the vacuum cleaner to

evacuate dry substances, a filter bag

must always be inserted in the

container. Then the evacuated material

can be disposed of easily.

A filter bag must be used without

exception when evacuating noxious

substances!

The filter element becomes damp after

evacuating liquids. A damp filter element suffers

more wear and tear if it is used for dry

materials. Accordingly, the filter element should

be dried or replaced with a dry one before dry

operation.

4.2 Vacuuming liquids

The filter bag has to be removed before

evacuating liquids.

We recommend use of a special wet filter.

Do not evacuate combustible liquids!

If foam or liquid escapes, stop work

immediately and empty the dirt container.

4.3 Volume flow monitoring

If the air speed in the suction hose drops below

20 m/s, an acoustic warning signal sounds for

safety reasons.

Possible causes and adjustments:

 Cause

- Adjustment

Suction force regulator (1.10) set to a too

low value

- Adjust suction force regulator to a higher

value

Rotary knob (1.3) not adjusted to the

connected hose diameter

- Adjust to correct hose diameter

 Suction hose blocked or twisted

- Remove blockage or twist

Filter bag full

- Change filter bag

Filter element dirty

- Change filter element

- Only when operating without a filter bag:

clean filter element

Electronic monitoring system malfunctioning

- Call Festool customer service for

adjustment

5 After finishing work

- Switch off the cleaner and pull the plug of the

mains lead out of the plug socket.

- Empty dirt tank.

- If noxious dusts have been extracted, the

vacuum cleaner and all accessories must be

completely cleaned (inside and outside) by

suction and wiping, before removal from the

contaminated area. Parts that cannot be

completely cleaned are to be packed for

transport in a plastic bag with an airtight seal.

The suction opening (1.7) must be sealed

with the blanking plug (1.6) for transport

purposes.

- Deposit the appliance in a dry room, safe from

unauthorised use.

6 Temperature control

Always remove the mains plug from

the socket before carrying out any

maintenance work!

Any maintenance and repair work

requiring an opening of the motor

housing may only be carried out by an

authorised customer service

workshop.

A safety test is to be carried out at least once

a year by the manufacturer or an instructed

person, e.g. for possible damage to the filter

and leaks in the appliance, and to ensure that

the control devices are functioning.

7 Accessories, filter

The accessory and filter order number can be

found in your Festool catalogue or on the

Internet under www.festool.com.

8 Warranty

Our equipment is under warranty for at least

12 months with regard to material or

production faults in accordance with national

legislation.

In the EU countries, the warranty period is 24

months (an invoice or delivery note is required

as proof of purchase).

Damage resulting from, in particular, normal

wear and tear, overloading, improper handling,

or caused by the user or other damage caused

by not following the operating instructions, or

any fault acknowledged at the time of

purchase, is not covered by the warranty.

Complaints will only be acknowledged if the

equipment has not been dismantled before

being sent back to the suppliers or to an

authorised Festool customer support work-

shop. Store the operating instructions, safety

notes, spare parts list and proof of purchase

in a safe place.

In addition, the manufacturers current

warranty conditions apply.

Note

We reserve the right to make changes to the

technical data contained in this information as

a result of ongoing research and development

work.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Festool SRM 312 LE-AS in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,83 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Festool SRM 312 LE-AS Manual

Product: