499198
7
Zoom out
Zoom in
Previous page
1/54
Next page
7
GB
Technical data SRM 312 LE-AS
Power consumption 350 - 1,200 W
Connected load to appliance
plug socket max.
EC 2,400 W
CH, DK 1,100 W
GB 1,800 W
AUS 1,200 W
Volume flow (air) max. 228 m³/h
Vacuum max. 23,000 Pa
Filter surface 10,500 cm²
Suction hose Ø 27 mm x 3.5 m
Sound pressure level
in compliance with EN 60704-1 59 dB(A)
Container capacity 63 l
Dimensions LxWxH 560x590x975 mm
Weight 26.5 kg
Power cable length 7.5 m
Explosion protection
designation II 3D T4 IP 54
The specified illustrations can be found at the
beginning of the operating instructions.
Pictograms
Note, Danger!
Manual, read the instructions.
1 Intended use
- The vacuum cleaners are designed as
specified for the aspiration and evacuation
of noxious dusts industrial threshold limit
values (LTL-values) up to 0.1 mg/m³ and of
wood dusts corresponding to dust class M
in accordance with IEC 60335-2-69.
- The vacuum cleaners are designed as
specified for extracting water.
- The vacuum cleaners are designed in
accordance with EN 60335-1 and EN 60335-
2-69 for a higher loading in industrial use.
- From a safety viewpoint, the mobile dust
extractor is suitable for extracting dry,
combustible, dust materials from explosion
classes ST 1, ST 2 and ST 3 in zone 22. De-
signation as per Ex-RL 94/9/EG: Group II,
category 3D, suitable for areas where there
is not usually an explosive atmosphere, and
if so, only occasionally and for short periods.
- The mobile dust extractor must not be used
to extract matierals that may cause a
dangerous reaction when coming in contact
with water.
- When extracting magnesium, additional
safety measures must be taken.
- The mobile dust extractor must not be used
for extraction at processing machines (object
extraction) if there is a danger that active
ignition sources are also extracted.
- From a safety viewpoint, the mobile dust
extractor is not suitable for extracting
materials capable of exploding as per §1,
Explosives Act, for combustible fluids or
mixtures of combustible dust and fluids.
The user is liable for damage and injury
resulting from incorrect usage!
1.1 Safety instructions
The appliance may contain dust that is
hazardous to health. The appliance
must not be emptied, nor must
maintenance work, including filter
changes, be carried out, by anyone
other than authorized specialist
personnel with appropriate protective
equipment. Do not operate the
appliance without a fully installed filter
system.
- When handling and extracting dusts that are
hazardous to health, the safety regulations
applicable in your country as well as the
specifications of the material manufacturer
must be observed without fail.
- Only use original Festool accessories.
- If used to extract dusts with LTL values or
large quantities of beech or oak sawdust,
only one dust source (electric or air tool) may
be connected.
- Do not use to extract aggressive liquids (e.g.
acids, alkalis, solvents).
- Remove plug from mains socket when not
in use and before maintenance work.
- Do not pull plug out of mains socket by its
cable.
- Protect the cable against heat, oil and sharp
edges.
- Check the plugs and cables regularly and have
them replaced by an expert if damaged.
- Do not leave devices out in the rain.
- Do not lift or carry the devices by their handles
using a crane hook or lifting gear.
- The device may only be used by persons who
have been trained in its use and who are
authorised to do so.
- For safety reasons, only operate the machine
using a totally earthed socket.
2 Appliance preparation and initial
operation
Stick the enclosed sticker in your national
language on the text area of the warning plate
(1.13).
2.1 Assembling the device
The accessories are delivered horizontal in the
container (1.5), and must be removed prior
to initial operation.
- Open locking clips (1.4), remove top section
(1.2),
- Insert filter bag as per instructions (see print
on filter bag). Important: Push filter bag
collar (3.2) onto intake fitting (3.1) with some
force.
- Replace top section of extractor and close
locking clips.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Festool SRM 312 LE-AS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Festool SRM 312 LE-AS in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info