724593
23
Zoom out
Zoom in
Previous page
1/44
Next page
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL: №. SBC52 • 02/2020 • 700710
52cc 2 Stroke Brushcutter / Line Trimmer
21
Changing the line only on the Spool and Line Assembly
NOTE: Always ensure the engine is turned o before undertaking this
assembly.
NOTE: The spool provided on this product is a rapid or easy wind type spool.
There is no disassembly of the spool components. The following steps will
guide you through the process.
NOTE: The spool & line assembly (35) does not need to be removed from the
lower shaft (15) of the line trimmer, however, if it is easier, it can be removed
from the lower shaft (15), especially for the rst time you re-load / re-wind
the line & become familiar with the process.
The line to suit this type of spool assembly is 2.5mm diameter line, with a
length not exceeding 2.6m.
1. Remove any existing line protruding from either eyelets in the spool
assembly (35). If there is no line left inside the spool, the line can easily
be pulled outwards from the eyelets. If the line will not pull out and is
jammed, the spool will need to be opened and the jammed line released.
Refer to the section on “Clearing a Jammed
Spool” following this section.
2. Cut a length of 2.5mm diameter nylon line to a
length of 2.6m, ensuring the line is cut cleanly.
If the rst 150mm of line is curved, try and
straighten the line as much as possible for entry
into the spool.
3. Align the outwards pointing arrow on the bump
knob (34) with either of the eyelet holes (Fig Y)
on the outside of the spool housing. This will
allow the line to be threaded through the spool
to the opposite side.
4. Insert one end of the line through the eyelet
until it passes through the spool and out
through the opposite side. (Fig Z) The line
should pass through the spool with the rst
150mm of line. If it does not pass through the
Y.
Z.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex SBC52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex SBC52 in the language / languages: English as an attachment in your email.

The manual is 6,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info