779769

Ferrex Q1W-SP07-2200A Manual

16
Zoom out
Zoom in
Previous page
1/27
Next page
3. Close the water tap for the water inlet.
4. Push the trigger until the pressure in the washer has been released.
5. Lock the trigger by pushing downwards onto the safety lock 14 .
Adjusting the handle
The handle can be adjusted in two positions. The washer is supplied with a lowered
handle.
1. Press the button 8 for the height adjustment and pull the handle 1 upwards until
it locks into place. The washer can be used and easily moved in this position.
2. Press the button again to lower the handle and push the handle downwards
until it locks into place.
Using a self-suctioning washer
Alternatively, you can also supply the washer from an open reservoir (water butt,
industrial water tank).
Use a suction hose with a suitable suction basket to protect the pump from foreign
bodies. We recommend using a high-quality suction hose made of reinforced
material, the diameter of which should be at least 13 mm and the maximum length
3 m. You can achieve the best results by integrating a non-return valve and filter in
addition to the suction basket.
To connect the suction hose, please proceed as follows:
1. Place the washer in close proximity to the water source on a stable and level
surface. Observe the maximum recommended suction height of 0.5 m.
2. Fill the suction hose with water and allow all of the entrapped air to escape.
3. Connect the suction hose to the washer. Remove all attachments.
4. Switch on the washer and press the trigger 13 until the washer discharges a
steady stream of water. If this is not achieved within 2 to 3 minutes, switch the
washer off and check the suction hose for entrapped air.
5. Switch off the washer and connect the desired attachment.
6. Operate the washer as usual.
In addition, please refer to the user manual of the relevant accessory part.
Operation
16
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex Q1W-SP07-2200A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex Q1W-SP07-2200A in the language / languages: English as an attachment in your email.

The manual is 1.55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info