724587
12
Zoom out
Zoom in
Previous page
1/20
Next page
30W Wood Burning Kit
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL:
PSI30 • 05/2020 • 701256
(toll free)
05/2020
9
WARNING: Do not leave the device unattended during the heating
process.
5) You can use the supplied template (10) to brand letters and numbers.
6) Hold the device on the handle like a pen while working.
7) Test the branding eect initially on a sample piece of material.
8) Turn o the mains power switch, and disconnect the plug from the
mains socket after nishing your work and allow the device to cool down
for at least 30 minutes.
WARNING: Do not leave the device unattended during the cool down
process.
WARNING: Exert as little pressure as possible on the hot branding
accessories. They are made out of brass and could become deformed if
too much pressure is applied. The branding eect should mainly be created
by the heat.
WARNING: Larger branding accessories may cool down a little during
the branding process. In this case, wait a few minutes until the
branding accessories has heated up again fully.
4. Soldering (Fig E1-E2)
1) Screw the desired soldering tip (5) onto the
branding rod (2) as described in "Fitting the
soldering tip and the branding accessories" (Fig
E1).
2) Place the branding rod onto the stand (9) so
that the Y-shaped mount on the stand supports
the branding and soldering iron between the
sleeve and the handle (Fig E2).
3) Connect the power plug into a mains power
socket, and then turn the mains power switch
on. The device is now heating up.
4) Wait for approx. 10 minutes until the
soldering tip has heated up fully.
WARNING: Do not leave the device
unattended during the cool down process.
5) Hold the device on the handle like a pen while working.
E1.
E2.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex PS130 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex PS130 in the language / languages: English as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info