724587
11
Zoom out
Zoom in
Previous page
1/20
Next page
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
30W Wood Burning Kit
PSI30 • 05/2020 • 701256
05/2020
8
Operation
WARNING: Before using your device, be sure to read the
instruction manual carefully.
1. ON/OFF switch
To start the device, connect the power plug to the mains socket and turn
on the mains power switch. To turn o it, turn the mains power switch o,
then remove the power plug from the mains socket.
WARNING: Never heat up the device without a tip or accessory tted to
the device. Never leave the device unattended while heating up.
2. Safety stand (Fig C)
The safety stand is closed upon purchase, inside
the case. Open the safety stand by ipping up
the middle section as shown in Fig C before
operation. The stand is handy for resting the
device or assisting with operation.
3. Branding (Fig D1-D2)
1) Screw the desired branding accessories
(1/8) onto the branding rod (2) as described
in "Fitting the soldering tip and the branding
accessories" (Fig D1).
2) Place the branding rod onto the stand (9) so
that the Y-shaped mount on the stand supports
the branding and soldering iron between the
sleeve and the handle (Fig D2).
3) Connect the power plug into a mains power
socket, and then turn the mains power switch
on. The device is now heating up.
4) Wait for approx.10 minutes until the branding
accessory has heated up fully.
C.
D1.
D2.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex PS130 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex PS130 in the language / languages: English as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info