734927
22
Zoom out
Zoom in
Previous page
1/34
Next page
Preparation
20
8. Hold the spindle lock
1
down and use the spanner to tighten the clamping
flange’s screw connection by turning it clockwise.
9. Ensure that the grinding/cutting disc is correctly, securely and firmly attached to
the spindle. To do this, turn the grinding/cutting disc by hand and ensure that the
grinding/cutting disc is properly secured and rotates. The grinding/cutting disc
must not wobble.
Adjusting and changing the disc guard
WARNING!
Risk of injury!
There is a risk of injury if you improperly install or align the disc
guard.
Use the disc guard
7b
only in the closed position when
carrying out cutting work.
Use the disc guard
7a
only in the open position when carrying
out grinding work.
Always position the disc guard such that the closed side of
the disc guard faces the operator, to protect the operator from
sparks and abrasion.
Adjusting the disc guard
The grinder is delivered with the disc guard for rough machining al-
ready installed.
Follow the steps described below if you want to change the disc guard’s position
7a
or
7b
adjust it to the respective working conditions:
1. Switch the grinder off and remove the battery from the battery holder
5
.
2. Completely open the fastening clamp
12
on the installed disc guard (see Fig.B).
Pull back the lever of the fastening clamp on the neck of the disc guard and
remove the fastening clamp from the hook on the disc guard.
3. Turn the disc guard clockwise or anti-clockwise on the holder
13
on the grinder
in order to correctly position the disc guard.
4. When the disc guard is in the desired position, again guide the fastening clamp
over the hook on the disc guard.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex FAW 40-I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex FAW 40-I in the language / languages: English as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ferrex FAW 40-I

Ferrex FAW 40-I User Manual - German - 36 pages

Ferrex FAW 40-I User Manual - French, Italian - 101 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info