.
•
.
•
.
• ( )
,
.
•
,
/
.
•
,
( ).
• ,
,
.
,
, ,
.
.
•
.
,
.
•
.
• :
- ,
-
,
- ,
,
- .
.
-
( ).
• ,
,
.
•
.
• ,
.
• ,
.
• ,
.
3.
,
.
.
(. 1).
•
,
(5)
. ,
,
.
• (10)
(6).
•
.
• (6)
(5) (7)
(8).
• (11 12).
:
4
.
•
(4) .
•
.
•:
.
•
24
.
•
.
,
10-16 Nm.
•
.
4.
. ,
2800, , ,
.
,
,
.
.
64 Ferm
4. USE
Operation
The essence of operation of the lawnmower is a hori-
zontally cutting knife fastened to the vertical shaft of
the motor; the knife, which rotates with a speed of
approximately 2800 r/min. cuts the grass at the pre-
selected height. Cut grass is thrown into the bag via an
aperture in the rear side of the lawnmower under the
impact of centrifugal force and the pressure resulting
from the rotation of the knife. Proper positioning of
the knife is of great significance for this process.
Switching ON and OFF (fig.2)
1. push the round button with one hand
2. draw and hold the switch handle with another hand
3. release the round button
4. hold the switch handle during the entire period of
lawnmower operation
5. releasing the switch handle will switch off the lawn-
mower
User tips
Please remember the most important rule for lawn care
- mow grass instead of plants growing therein. The
mowing procedure shall be repeated once in two-to-
three days with grass growing again fast. Lawnmower is
equipped with a reservoir for the collection of mowed
grass, the so-called bag, relieving of the necessity to rake.
NB: mowing of humid plants results in a significant
decrease in efficiency of grass collection in the bag.
ATTENTION!
•Do not mow wet grass with the lawnmower!
•Select the desired height of mowing before starting
up the appliance. All wheels shall be set on the
same level. Wheel axles shall be screwed on pro-
perly. A loose wheel may fall under a rotating knife.
•Running over the electric cord on the ground with
the operating lawnmower is prohibited. To pre-
vent running over the cord, we recommend han-
ging it on the shoulder of the lawnmower’s opera-
tor.
•Push the lawnmower carefully or drag it before
yourself whenever operating the appliance.
•Start the motor up after the connection of the
extension cord only.
•Overfilling of glass reservoir is not recommended.
•Do not mow if the grass bag has not been arranged
and the rear cover is lifted, which may RESULT
IN INJURY!
Observe all the above-mentioned requirements carefully.
Start mowing from the place closest to the power
source (fig. 3).
5. SERVICE & MAINTENANCE
WARNING! Unplug the electric cable (power
source) prior to any maintenance or preparatory
storage operations.
Cleaning
Grass or soil residues shall be removed with a brush
and wooden trowel.
Clean the housing regularly with a soft cloth, prefera-
bly every time it is used. Remove stubborn dirt with a
soft rag moistened in soapy water. Do not use any sol-
vents such as petrol, alcohol, ammonia, etc. as such
substances can damage the plastic parts.
ATTENTION! Washing of the lawnmower
under a sheet of water is prohibited - the water-
tightness of the body secures the IP 34 class only
(is not entirely water-tight)!
Maintenance
Inspect the wear-out of main units periodically.
Deterioration in mowing quality, detected after a cer-
tain period of time, may signify that the blade of the
lawnmower has got blunt.
The following regulations shall be observed for the
sharpening of blade:
•the blade shall be cooled constantly during sharpe-
ning to prevent inadmissible overheating
•the blade shall be sharpened evenly on all sides to
prevent vibration of the blade during operation
•if you note any cracks or slits, the blade shall be
replaced with a new one (as well as in the case
where the area of the blade decreases by over 5
millimeters during sharpening)
Lubrication
The appliance does not need any extra lubrication.
STORAGE AND TRANSPORTATION
Keep the lawnmower in well-ventilated dry premises
with temperature not going below +5ºC.
We recommend unscrewing of wheels during trans-
portation, which will prevent the lawnmower from
moving freely. When transporting the lawnmower on
longer distances or when forwarding thereof, dismant-
ling and placing of lawnmower into the manufacturer’s
packing (box) is advised.
TROUBLESHOOTING
Failure Cause / solution
The machine fails Machine is not switched on correctly
to operate /see chapter 4. USE
Extension cable damaged / inspect cable,
replace if damaged
Machine functions Extension cable damaged / inspect cable,
intermittently replace if damaged
Machines internal wiring damaged
/contact service centre
Mowing result is Check mowing-height (wheels) / see
irregular / rough Chapter 3. ASSEMBLY
Cutting blade is blunt Inspect blade, shar-
pen or replace the blade
Ferm 5
