Manual Falmec Ellittica - wall (page 28 of 88) (English, German, French, Italian, Polish, Portuguese, Spanish, All languages)

709781

Zoom out

Zoom in

1/88

until it is hooked to the flange, then fasten permanently with the M3 metric screw provided.

- Power the hood in accordance with applicable regulations (see sect. D of this booklet).

WALL HOOD

Fig. W01-W02

- Locate the desired height between the hood and the bob (see sect. C).

- Remove the back (A) by removing the cover caps (T) and loosen the inside fastening screws

(V1).

- Mark the 4 drilling points F, according to the dimensional specifications shown in the figure,

or use the back as a drilling template.

Fig. W03-W04

- Fasten the back (A) to the wall using the 4, 8 mm Ø expansion plugs, and the screws (V2)

provided.

- The horizontal and vertical alignment of the back with a spirit level.

Fig. W05-W06

- For the exhaust version, (define the upper and lower output use) locate the optimal length

of the fumes exhaust pipe (F) and connect. To facilitate the operation, if the ceiling height

allows it, cover B can be temporarily removed by acting on fastening screws. Carry out elec-

trical connections only after disconnecting the power supply. For the filter version, make

sure the exhaust on cover B is free to allow the air purified by carbon filters to be exhausted.

- Attach the hood to the back using the 4 hooks (G) ensuring the hood is down by approx 10

mm, to check its tightness.

Fig. W07-W08

- Tighten, but not completely, the two upper fastening screws (V1).

- Lift the hood to the desired position and tighten the upper and lower fastening screws com-

pletely (V1).

- Power the hood in accordance with applicable regulations (see sect. D of this booklet).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Falmec Ellittica - wall in the language / languages: English, German, French, Italian, Polish, Portuguese, Spanish, All languages as an attachment in your email.

The manual is 2,79 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Falmec Ellittica - wall Manual

Product: