76488
24
Zoom out
Zoom in
Previous page
1/32
Next page
24
Pressure testing
The gas pressure can be measured at the pressure
test point on the gas connection block.
Connect the pressure gauge. Turn on and light one
of the hotplate burners.
For Natural Gas the pressure should be 20mbar.
For Propane the pressure should be 37mbar.
Electrical Connection
This appliance must be installed by a qualified
electrician to comply with the relevant regulations
and also the local electricity supply company
requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct
electrical supply as stated on the voltage label on the
cooker, through a suitable cooker control unit
incorporating a double pole switch having a contact
separation of at least 3mm in all poles. This cooker
must not be connected to an ordinary domestic
power point.
The total electrical load of the appliance is
approximately 7.2kW. The cable size used should be
suitable for this load and comply with all local
requirements.
Access to the mains terminal is gained by removing
the electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for
your electrical supply type.
Check that the links are correctly fitted and that the
terminal screws are tight. Secure the mains cable
using the cable clamp.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30-milliamp
sensitivity residual current device (RCD), the
combined use of your cooker and other domestic
appliances may occasionally cause nuisance
tripping. In these instances the cooker circuit may
need to be protected by fitting a 100mA device. This
work should be carried out by a qualified electrician.
Hotplate
Check each burner in turn. There is a flame safety
device that stops the flow of gas to the burner if the
flame goes out. There is also a spark ignition system
that works when the knob is pressed in.
For each burner, push in and turn the knob to the
large flame symbol ( ).
The igniter should spark and light the gas. Keep
holding the knob pressed in to let the gas through to
the burner for few seconds.
If, when you let go of the control knob, the burner
goes out, the safety device has not held in. Turn the
control to the off position and wait one minute, then
try again this time holding in the control knob for
slightly longer.
Grill
Open the grill compartment door. Turn on the grill
control and check that the grill heats up.
Oven check
Turn on the ovens and check that they start to heat
up. Turn off the ovens.
Fitting the plinth
Remove the 3 screws along the front bottom edge of
the cooker. Hold the plinth in place and refit the 3
screws.
Customer care
Please inform the user how to operate the cooker
and hand over these instructions.
Thank you.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Falcon 900 Deluxe at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Falcon 900 Deluxe in the language / languages: English as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info