798845

Everdure Force Manual

6
Zoom out
Zoom in
Previous page
1/13
Next page
1110 Assembly, Operation & Maintenance InstructionsAssembly, Operation & Maintenance Instructions
LIGHTING THE BARBEQUE USING THE BUILT IN
IGNITION ON THE CONTROL KNOBS
The FORCETM and FURNACETM barbeques have a rotary ignition system built into the
gas valves, accessed by using the control knobs built into the right hand servery. To ignite
a burner, push the appropriate control knob down and slowly rotate anti clockwise. This
starts releasing the gas into the burner. As the knob reaches the ignition symbol on the
control panel, a spark will ignite the gas in the burner. The knob can then be rotated
the rest of the way to “HIGH” and released, or adjusted to the appropriate temperature
setting.
If the burner does not ignite, return the control knob to the “OFF” position and retry.
If there is still no ignition after 5 attempts, leave the barbeque o and retry again in 5
minutes time.
There are 2 control knobs on the FORCETM barbeques and 3 control knobs on the
FURNACETM barbeques (one for each burner under a plate or grill). The control knob
closest to the rear controls the burner to the right. The control knob closest to the front
controls the burner to the left. The central control knob (FURNACETM barbeque only)
controls the centre burner.
CLEANING & STORAGE
EXTERNAL CLEANING
Before cleaning the barbeque exterior and stand, ensure the appliance has cooled and
is safe to touch. Painted and plastic surfaces can be cleaned using a mild household
detergent or cleaner and a clean cloth (do not use scourers or harsh detergents). It is
advisable to test cleaners on a small section of the appliance rst. NEVER use
paint thinners or similar solvents for cleaning and NEVER pour cold water over hot
surfaces. Dry the surface afterwards.
INTERNAL CLEANING
Before cleaning the internal parts of your barbeque, ensure the appliance has cooled and is
safe to touch. The inside of the hood can be cleaned by using some water, mild detergent
and a sponge or mild scouring pad. The non-stick coated surface of the hot plate should
be cleaned carefully so as not to scratch the surface as above, preferably when the
surface is still warm. For hard to clean areas, use a little baking soda on a wet sponge. Do
not use abrasive cleaners.
WARNING! The surfaces of the plates may be hot. Please ensure protective gloves are
worn.
IGNITION PROCEDURE
READ ALL OPERATING INSTRUCTIONS BEFORE LIGHTING THE APPLIANCE
OPEN THE HOOD BEFORE LIGHTING
MAKE SURE THE GAS CONTROL KNOB IS IN THE ‘OFF’ POSITION AND OPEN CYLINDER VALVE OR CONNECT THE
NATURAL GAS SUPPLY (AFTER NG CONVERSION ONLY)
MAKE SURE THE GRILL AND PLATE ARE IN THE CORRECT POSITIONS FOR COOKING
WARNING: STORE CYLINDER IN A WELL VENTILATED AREA OUT OF REACH OF CHILDREN
WARNING! The surfaces of the open grills may be hot. Please ensure heat resistant
gloves are worn.
STORAGE
When the appliance is not in use, the cylinder valve must be turned OFF, the barbeque,
stand and the cylinder together must be stored outdoors in a well ventilated area.
However it is permissible to store the appliance (but not the cylinder) indoors. Ensure the
cooking surface is clean before storing away.
When the gas cylinder is disconnected, replace the plug or cap on the valve outlet. For
extended storage it is suggested that the primary air-port of the burners be covered against
the penetration of insects or vermin. Spiders and small insects can spin webs or nest in the
burner rails/tubes, which could lead to obstruction in the gas and air ow, resulting in a re in
an around the burner rails/tubes. This type of re is called a ash-back and can cause serious
damage to your barbeque and create an unsafe operating condition. To prevent this, regularly
inspect and clean the burners. Use an Everdure Heston Blumenthal FORCETM or FURNACETM
barbeque cover for extra protection, and to reduce this.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Everdure Force at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Everdure Force in the language / languages: English as an attachment in your email.

The manual is 6.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info