591588
32
Zoom out
Zoom in
Previous page
1/52
Next page
32
IV - OPERATION
N.B.!
- the generator is transported without oil. If you fail to fill the oil reservoir the generator will
not start.
- Ensure that the generator is completely level when filling up with oil. Tilting could result
in overfilling and damage the engine.
IV-1 Starting the engine
N.B.!
- Do not connect any electrical equipment before starting the engine
- Switch the Economy switch to the OFF position
a) Open the ventilator knob on the tank cap (See II-
5)
b) Open the fuel cock (See II-6)
c) Switch the engine switch to the ON position
d) Set the choke lever to the position (CHOKE).
The latter is not necessary if the engine is still
hot.
e) Pull the starter cord out slowly until you feel
resistance. That is the ‘point of compression’.
Let the cord run back in to the starting position
and now pull hard. At the same time hold the
generator firmly in position by the handle to
prevent it falling over when pulling. Do not pull the
cord out all the way. After starting let the starter
cord run back to its starting position without
releasing the handle. Repeat if necessary, if the
engine doesn't start the first time.
f) Let the engine run warm
g) Push the choke lever back to its operating position RUN.
h) Allow the generator a few minutes to run warm without a load.
IV-2 Connecting up electrical equipment
A AC Alternating current use
i) Check whether the AC indicator light shows that the voltage level is correct
j) Set the Economy switch to the ON position
k) Ensure that all equipment to be connected is switched off prior to connecting
l) Plug the plug(s) from the equipment into the sockets on the generator.
Warning!
Be sure that the equipment being connected is switched off
Ensure that the total connected capacity does not exceed the maximum
Be sure that the required and supplied voltage is the same.
The Economy switch must be switched off if you use electrical equipment that requires
high peak current, like a compressor or a submersible pump.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom Independ-2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom Independ-2500 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info