Manual Eufab 11417 - James (page 9 of 24) (English, German, French, Italian)

807233

Zoom out

Zoom in

1/24

Personal injury or property damages caused by protruding parts.

• Parts protruding beyond the edge of the vehicle or rack may cause

personal injury or property damage during the journey

• Only mount parts that do not protrude beyond the edge of the vehicle..

Personal injury or property damage due to overloading.

• Exceeding the maximum payload of the bicycle rack and the permitted

supporting load of the trailer tow bar or permitted overall weight may

lead to serious accidents.

• Always observe the speci cations regarding the maximum payload,

permitted supporting load and permitted overall weight of your vehicle.

Do not exceed these speci cations at any time.

Personal injury or property damage possible due to a damaged

bicycle rack.

Damage to the rack, e.g. by bent parts, cracks or scratches, prevents the safe

operation of the rack.

• Do not mount the bicycle rack if it is damaged in any way.

• Follow the steps as described in the chapter on „Maintenance”.

Property damage due to opening tailgate.

• The tailgate could hit the bicycle rack and be damaged.

• Switch o the electric tailgate and operate it manually.

Damages may be caused to the rack or bicycles if the exhaust outlet is close

by.

• Use an exhaust de ector if necessary.

Property damage caused by hot exhaust gases.

Personal injury or property damage due to loss of the bicycle rack

while driving.

A loose or faulty connection between the bicycle rack and trailer tow bar

can lead to the detachment of the bicycle rack.

• Replace a defective trailer tow bar.

• Clean the trailer tow bar of dirt, dust and grease.

Damaged may be caused by parts that can be lost if they come away from

the bicycle during the journey.

• Remove all parts that may be lost before starting your journey, these

include air pumps, battery-powered lamps, navigation systems, bicycle

computer, tool bags or baskets.

Personal injury or property damage possible due to loss of bicycle

parts while driving.

Base frame with Quick closing

mechanism

U-bracket

2 x Lock screw M8 x 60

2 x Washer 15.8 x 8.3 x 1.2

2 x Knob nut M8

5. OPERATING INSTRUCTIONS

5.1.1 MOUNTING THE UBRACKET

Now  t the U-bracket onto the intended pipe sleeves. Push the lock screws

M8 x 60 from the outside, through the drilled holes of the U-bracket and the

pipe sleeves. Place the washers and knob nuts M8 on the ends of the screws

and tighten the knob nuts  rmly.

5.1 MOUNTING THE BICYCLE RACK

The bicycle rack must  rst be assembled. Take all of the components out of

the packaging and set them out clearly. Check the scope of delivery. Every

stage is described and clearly shows which components are required for the

assembly of the rack.

4 x Wheel rails halves

2 x Strap guide 2 x Link screw M6 x 25

5.1.2 MOUNTING THE WHEEL RAILS

• Damaged or worn straps must be replaced with undamaged ones before

you embark on your journey. Only straps authorised by EAL GmbH for the

purpose may be used.

The general operating permit must be carried in the

vehicle when the rack is mounted.

Do not travel with the bicycle rack empty. Store it in

the boot of your vehicle. This prevents increased fuel

consumption and protects the rack.

The driver is always responsible for ensuring that the

load and the load securing meet the regulations.

Personal injury or property damages caused by increased wind

loads

The bicycle rack and trailer tow bar may be damaged by too high a wind

load.

• Remove all bags from the bicycle before starting your journey.

• Do not use protective covers for the bicycle during the journey.

The U-bracket is delivered approx. 5 cm wider at the lower end

than the mounts, i.e. the pipes are not parallel when loose. Du-

ring assembly, the ends of the tubes must be pressed together.

The purpose of the pre-tensioning is, the U-bracket can be

folded down „rattle-free“ for space-saving stowage.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eufab 11417 - James in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 0.98 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eufab 11417 - James Manual

Product: