802071
11
Zoom out
Zoom in
Previous page
1/12
Next page
9 | 10
The top connector is the first phase (L1) of the charging
station and it will be used to charge single-phase EVs. It
is advisable that the least loaded phase of the facility is
used for this. Bottom connector should be used to
connect neutral wire (N). Keep the sequence of phases.
The right sequence of phases is especially important
when charging station is part of a cluster. After you
connect the wires, tighten the screws so that the wires
cannot be pulled out and sufficient electrical contact is
achieved.
Connect Ethernet/UTP Cable and Insert SIM Card
Connect the Ethernet UTP cable into the Ethernet
connector next to the protection element. If you are
using mobile data communication insert the SIM card
into the SIM card holder.
Attach the Service Doors and Remove the Holder
Attach the back-maintenance doors back onto the
enclosure and use the screw to secure it.
Remove the charging station off the holder and remove
the holder from the bracket. While doing this, hold the
charging station firmly as it is not supported anymore.
Attach Charger to the Wall Bracket
Attach the charging station to the wall bracket. First
attach it to the top hooks and gently push it towards the
wall. Tighten the screw until it is completely fastened
and charging station will be secured to the wall.
Installing Big Magnetic Cable Holder (Only for Model
with Longer Cable Attached)
Attach cable holder after you remove the charging
station from the station holder. To attach it, align the
holes on the cable holder hook with holes on the plate
attached to the enclosure.
Check Whether the Charging Station is Working
Properly
When the charging station has either overcurrent or RCD
protection installed, check whether the protection
element is in ON position.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etrel Inch at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etrel Inch in the language / languages: English as an attachment in your email.

The manual is 0.3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Etrel Inch

Etrel Inch Quick start guide - German - 12 pages

Etrel Inch Quick start guide - Dutch - 12 pages

Etrel Inch Quick start guide - French - 12 pages

Etrel Inch Quick start guide - Italian - 12 pages

Etrel Inch Quick start guide - Spanish - 12 pages

Etrel Inch Additional guide - All languages - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info