802071
10
Zoom out
Zoom in
Previous page
1/12
Next page
8 | 10
Insert the UTP cable through the gland and remove the
cable jacket from the cable. About 17 cm of UTP cable
should be pulled out of the gland. You can also remove
the jacket before putting the cable through the gland.
After the cable is pulled through the gland put the UTP
plug on the UTP cable without cable jacket. Use straight
connections of UTP wires, without cross-over of wires.
Length of cables on the other side of the gland should be:
a. Power supply cables (L1, L2, L3, N): 15 cm with
insulation and stripped cable jacket + 2 cm with
cable jacket
b. Grounding cable: 10 cm
c. Ethernet UTP cable: 17 cm
Mount Charging Station on Holder and Screw the Cable
Gland on the Enclosure
Mount the station on the holder which is already
attached to the mounting bracket. Holder is strong
enough to hold the charging station during the
installation of cables.
Place the gland plate in its position so that the plate
holes are aligned with holes of the enclosure. Make sure
that cables are long enough to be connected. Screw in
the gland plate using a Phillips-head screwdriver.
Secure Grounding Wire
Secure the grounding wire first. Otherwise there will not
be enough space to do it later.
Insert the Fork Wire (Only if RCD in the Charger)
To enable the tripping of RCD protection, insert the
additional wire with fork into the slot for neutral
conductor like shown on the figure. This applies only if
RCD is installed in the charging station.
Connecting the Connection Element
Remove the sticker with designation of conductors.
Insert all the wires into the RCD/overcurrent/MID meter
unit. Order of the wires and how they are connected is
important.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etrel Inch at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etrel Inch in the language / languages: English as an attachment in your email.

The manual is 0.3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Etrel Inch

Etrel Inch Quick start guide - German - 12 pages

Etrel Inch Quick start guide - Dutch - 12 pages

Etrel Inch Quick start guide - French - 12 pages

Etrel Inch Quick start guide - Italian - 12 pages

Etrel Inch Quick start guide - Spanish - 12 pages

Etrel Inch Additional guide - All languages - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info