621626

Ergofix 79525 Manual

21
Zoom out
Zoom in
Previous page
1/36
Next page
19
sliding seat section tailstock section
In the figure, (1) is a loosening screw, (2) is a tightening screw. When the gap is
too small, loosening (2), adjust (1) to fitness. This work has been done before the
machine leaves the factory, the user need to adjust only when the machine has
been used for a period of time and the slideway gap is excessively large because
of wearing. The tightening screw (2) of tailstock is also acted as a braking screw.
When the tailstock is needed to be moved, loosen the screw (2), push the tailstock
into the desired position, then tighten the screw (2) again.
5. Operation of other parts
Handwheels are set at tailstock, slide seat small tool carrier and right end of the
bed, use them to steer the motion of moving parts, the moving speed is depended
on the operator who turns the handwheel fast or slowly according to technological
requirement for working parts.
6.0 MAINTENANCE
Regular maintenance will increase durability and reliability of your lathe.
1. Every time before operation of the machine, oil the machine for lubrication
according to lubrication chart. After operation clean machine surfaces,
especially slideway surfaces.
2. Don't beat different surfaces of machine with heavy weight, especially the
spindle, slideway surface and leading screw, sleeve surface. If any damage
occurs, repair the impacted surface with an oil stone, so as to avoid drawing
damage of the coupling surfaces by burrs.
3. In use, the chip falling onto all the sliding surfaces should be cleaned out in
time.
4. After having done the work each day, you must clean out the chip and wipe all
parts of the machine tool, and coat it with machine oil in order to prevent the
machine from rusting.
5. To change the rotational speed of the spindle box, first of all, stop the machine,
and switch it according to the required speed and refering to the operating
position on the indicating plate.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ergofix 79525 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ergofix 79525 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info