691901
11
Zoom out
Zoom in
Previous page
1/16
Next page
EmpirBus Connect-50 User manual Ver. 1.33 10/14
Less common is window wiper circuit 2. See figure 6.3.
Any channel can be used for Ch X and Ch Y. Channel 3 or 4 is used as low speed channel. Note: The
diode is never connected to channel 3 or 4.
6.3!Serial!interface!
Depending on the model optional CAN and RS485 is available. See the table 4.1 for model
specification.
6.3.1!Optional!CAN-bus!
The optional CAN-bus is galvanic isolated, Ch 23 = CAN Hi and Ch 24 = CAN Low. LED indication 23 will
indicate when transmitting message “Tx” and LED indication 24 will indicate when receiving message
“Rx” to Connect-50.
Two external 120-ohm terminal resistor must be installed in each end of the CAN-bus.
6.3.2!RS485!
RS485 is galvanic isolated, Ch 30 = A and Ch 31 = B. LED indication 30 will indicate when transmitting
message “Tx” and LED indication 31 will indicate when receiving message “Rx” to Connect-50.
Two external 120-ohm terminal resistor must be installed in each end of the RS485-bus.
7. Configuration!(Not!existing!on!2110000!&!2110001)!
The settings covered by this chapter are settings that can be set directly on the unit. Some of these
settings can also be set from the EmpirBus Studio PC software, and some settings needs to be set
both in the PC software and on the unit. For further information, see the EmpirBus Studio
documentation.
7.1!Bus!ID!
All units needs to have a unique bus ID. On the Connect-50 the bus ID can be read from the display
on the upper left corner. Factory preset is bus ID 0 (000).
To change bus ID on a Connect-50 unit:
Figure 6.3: Window wiper circuit 2
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EmpirBus Connect-50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EmpirBus Connect-50 in the language / languages: English as an attachment in your email.

The manual is 2,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info