536726
18
Zoom out
Zoom in
Previous page
1/62
Next page
16
1. Press , ,
to put the system into Test mode.
‘WALK TEST’ will be displayed.
2. Press to activate Walk Test.
‘ Walk Test Waiting…’ will be displayed.
3. By pressing ON or OFF knob each time, the Smart
Home box will chime in response.
EXTERNAL CONNECTIONS
The Smart Home Box incorporates a terminal block for
connection of hard-wired Zones (33-36), Siren or
Telephone Dialer unit. The connection terminal block
is located inside the Smart Home Box behind the front
cover.
To access the terminal block
Press , ,
this puts the system into Test Mode and prevents an
alarm occurring. Undo the two fixing screws on the
top edge of the Smart Home Box and open the front
cover.
Before making any connections, ensure that the
memory jumper link P1 is in the ‘OFF’ position and then
remove the DC power jack and disconnect one of the
back-up batteries.
Hardwired zone and tamper switches should be Volt
free and Normally Closed, with the contacts opening in
order to initiate an alarm.
Note: Jumper link P51 (on top left corner) should be
fitted into the ON position only if the external hardwired
tamper circuit is used, otherwise it must be in the OFF
position.
After making your external connections, reconnect the
power supply and Back-up Battery. Then close the
Smart Home Box cover and tighten the fixing screws
on the top edge of the Smart Home Box.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro HIS20SF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro HIS20SF in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info