458070
9
Zoom out
Zoom in
Previous page
1/24
Next page
-2--3-
EN
CZ
A security code must first be entered using the Control Panel keypad.
This security number is to be selected by you and is used to arm and disarm the
unit. Enter your security code as follows:
1. Enter the factory preset security code “1, 1” then press “*”. (A single beep
will be heard).
2. Enter your own security code (up to four digits) then press “*” again. (A
musical tune will be heard).
To change your security code, repeat the above instructions but use your old
security code instead of the factory preset number.
WIRELESS WINDOW/DOOR SENSOR
CONTROL PANEL
Open the rear of the Wireless Window/Door Sensor and insert 1 x 9volt alkaline
battery, screw the reed switch to the wall using the screws provided and then
replace battery compartment lid.
Proper positioning of the Window/Door Sensor is important. Ensure that the
wireless reed switch sensor and magnet are parallel and the arrows are pointing
directly at one another. Separation between the pieces must not exceed 12mm
(1/2 inch.).
When the door or window is opened, the red LED will flash momentarily.
Prepare the installation of the Control Panel by putting two screws in the wall
137mm horizontally apart and at a convenient height above the floor and within
1-metre of a power point.
House Code Selection
By selecting each House Code switch “OFF” or “ON”, up to 16 different Codes
can be selected. Each Sensor has a similar set of switches in the battery
compartment of the device. Ensure all units have their House Codes set the
same.
Open the HA31S wiring compartment by removing the screw underneath the
Control Panel and remove the lid.
Insert the barrel plug from the AC Adaptor into the socket within the
compartment. Replace the wiring cover and screw.
Open the Control Panel battery compartment by removing the screw
underneath. Insert 3 x new “AA” size alkaline batteries and replace the battery
cover and screw (The piezo siren will emit a double beep).
Mount the Control Panel on the mounting screws prepared earlier. Switch the AC
adaptor on. Your Alarm System is now ready to be programmed.
PROGRAMMING
NASTAVENÍ & ODSTAVENÍ
Nastavte jednotku jednoduše zadáním vašeho bezpecnostního kódu a následným
stištením tlacítka „s klícem“, uslyšíte jedno pípnutí. Zelená LED bude svítit asi 30
sekund címž indikuje, že je jednotka nastavena. Pokud se neco pohybuje pred
Senzorem PIR Aktivovaným Pohybem, Rídící Panel bude svítit signalizujíc, že
Senzor PIR Aktivovaný Pohybem detekuje pohyb. 60 sekund poté co opustíte
dum, zelená LED zhasne a jednotka bude plne nastavena ( dum zastrežen ).
Jakmile budou nekteré ze zabezpecených dverí otevreny, cervená LED Senzoru
PIR Aktivovaného Pohybem zabliká a Rídící Panel jednou pípne, aby vás
upozornil že máte 8 sekund na odstavení jednotky. Pro odstavení, jednoduše
znovu zadejte váš bezpecnostní kód a stisknete tlacítko „klíce“. Jednotka vydá
dvojí pípnutí, címž signalizuje, že je odstavena.
Pokud není jednotka odstavena do 8 sekund, piezo siréna zacne vydávat hlasitý
zvuk, aby upozornila obyvatele domu na narušitele. Pro odstavení jednotky v
tomto prípade, jednoduše znovu zadejte váš bezpecnostní kód a stisknete
tlacítko „klíc“.
TECHNICKÁ SPECIFIKACE
Prodlení pri vstupu: 8 sekund
Prodlení pri odchodu: 30 sekund po té co nedetekován Senzory
pohyb
Indikace vybití baterie: CerveLED blipribližne jednou za sekundu
a ozývá se jedno pnutí kch 20 sekund.
Cas resetozvuku alarmu: 1 minuta
Indikace Naritele: Po ukoncealarmu bude svítit zeleLED
signalizujíc, že byl detekován narušitel
Výkon Alarmu: Priblne 110dB na 1 metr
Bezdrátový dosah vysílacu: priblne 25 metru
Dosah Pohybem Aktivovaných
Senzoru: priblne 7 metru, skenovací úhel 120
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro-Flamingo HA31S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro-Flamingo HA31S in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info