458070

Elro-Flamingo HA31S Manual

8
Zoom out
Zoom in
Previous page
1/24
Next page
-4--1-
CZ
EN
INSTALLATION & OPERATING INSTRUCTIONS
INSTALLATION GUIDE
WIRELESS PIR MOVEMENT ACTIVATED SENSORS
The HA31S is a simple self-contained alarm designed to give additional security
to your home. The HA31S protects the home by sounding a siren if its
Window/Door Sensor or PIR Movement Activated Sensors are activated. It can
be armed/disarmed with your own selected security code. All Sensors are
wireless transmitters so there is no messy cabling.
Select and determine where each product is to be located and installed. The
Window/Door Sensor is usually placed on front or rear doors but can also be
used to secure windows. The PIR Movement Activated Sensors are usually
mounted high on a wall and directed into the room requiring protection such as
a lounge room or hallway. The Control Panel is usually located somewhere near
the main entrance door and within 1-metre of the power point.
The Sensors must not be located more than 25-metres from the Control Panel.
The distance may be reduced by the number of doors and walls through which
the Sensors transmit.
All transmitters and the Control Panel are factory set to transmit on one of 16
House Code. During installation, ensure all Sensors and the Control Panel has
their House Code switches set to the same code.
The HA31S uses a Wireless Passive Infrared Detector (PIR) SA31P.
Screw the bracket to the wall. Open the rear of the PIR Movement Activated
Sensor and insert 1 x 9volt alkaline battery, replace the battery compartment lid
and screw then slide the Sensor onto the bracket plate. Adjust the PIR
Movement Activated Sensor so that it is directed toward the centre of the room.
Once movement has activated the sensors, the red LED will flash momentarily
and then extinguish for approximately two minutes. After this time, the unit will
again be ready to sense.
ODSTRANOVÁNÍ PROBLÉMU
PRÍSLUŠENSTVÍ
Pokud nastali po instalaci nejaké problémy, mohou být vyrešeny následující
prohlídkou.
1. Zkontrolujte, zda jsou všechny prepínace domovního kódu ve všech Senzorech a
Rídícím Panelu nastaveny stejne.
2. Dvere a zdi mohou snížit dosah na méne než 25 metru.
3. Rídící Panel
a) Zkontrolujte, že máte nové baterie a že jsou nainstalovány se správnou
polaritou.
b) Zkontrolujte, zda je AC adaptér správne pripojen a zapnut.
c) Zkontrolujte, zda byl osobní bezpecnostní kód správne zadán.
4. Bezdrátové Senzory PIR Aktivované Pohybem
a) Zkontrolujte, zda byla vložena správne baterie.
b) Zkontrolujte zda nejsou Senzory PIR Aktivované Pohybem dále než 25 metru
od Rídícího Panelu. Pokud je Senzor PIR Aktivovaný Pohybem upevnen poblíž
kovových objektu, je možné, že by mel být premísten.
c) Nastavte Rídící Panel a vstupte pred Senzor PIR Aktivovaný Pohybem.
Cervená led na Senzoru PIR Aktivovaném Pohybem a na Rídícím Panelu by
mela na chvíli zasvítit. Po dvou minutách, bude jednotka opet pripravena
snímat, zresetujte alarm a testujte znovu.
5. Senzor Oken/Dverí
a) Zkontrolujte, zda byla vložena správne baterie.
b) Zkontrolujte, zda mezera mezi cástmi není vetší než 12mm
c) Zkontrolujte zda Senzor Oken/Dverí není vzdálen více než 25-metru od
Rídícího Panelu. Pokud je Senzor Oken/Dverí upevnen poblíž kovových
objektu, je možné, že by mel být premísten.
d) Nastavte Rídící Panel a otevrete zabezpecené dvere. Cervená LED na Rídícím
Panelu by mela na chvíli zasvítit.
6. Kompaktní Prídavná Siréna (není soucástí balení)
a) Zkontrolujte, zda byla vložena správne baterie.
b) Zkontrolujte, že jsou kabely správne pripojeny, a že nedošlo k jejich
poškození v prubehu instalace.
Pro další rozšírení mohou bát 2 sady „spojeny“ Upozornení: Domovní kód musí
být nastaven shodne.
Dále mužete k systému HA31S pridat Kompaktní Prídavnou Sirénu.
- Pripojte dráty Sirény k prípojkám „Ext. Siren“ uvnitr prihrádky kabeláže
Rídícího Panelu.
- Vyvedte dráty do jiné místnosti ci mimo dum pod okap a vložte do Prídavné
Sirény 4x “AA” baterii.
- Prídavná Siréna bude nyní znít soucasne se sirénou Rídícího Panelu.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro-Flamingo HA31S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro-Flamingo HA31S in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info