708667

Elro AP5500 - Pro Alarm System Manual

40
Zoom out
Zoom in
Previous page
1/49
Next page
.
OPERATING INSTRUCTIONS
When leaving the premises, the system must be Armed.
However, before doing so, check that all windows are
closed and locked, all protected doors are closed and
PIR Detectors are not obstructed. Ensure that pets
are restricted to areas not protected by PIR Detectors.
The system has three arming modes, ARM, Part-Arm 1
and Part-Arm 2. The Part-Arm modes allow for
selected zones to be left in a Disarmed state while the
reminder of the system is Armed.
When the system is Armed (in any mode) the Control
Panel will display the arming mode and the status of
the Latch Key for a few seconds. If enabled, the
system Exit-Delay will start and be counted down on
the display. As the Exit-Delay expires the Control
Panel will beep, with the beep rate increasing in steps
as the delay expires. At the end of the Exit-Delay all
active zones be Armed. By this time the user must
have left the property and closed the final exit door.
If while the system is armed a detector on an active
zone is triggered, if enabled, the programmed Entry-
delay for that zone will start and be counted down
on the display. As the Entry-Delay expires the Control
Panel will beep, with the beep rate increasing in
steps as the delay expires. If the system has not
been disarmed when the Entry-Delay expires an alarm
will occur. If however, the Entry-Delay for the
triggered zone has been disabled an alarm will occur
immediately.
At the end of the programmed alarm duration the Siren
and Control Panel alarms will stop and the system will
automatically re-Arm.
ARM
The system can be set in ARM mode using either the
Remote Control or the Control Panel as follows:
Remote Control:
Press the ‘ARM’ button, .
Control Panel:
Press the Arm button followed by the User
Password and then the Enter button:
User Password
By pressing , the programmed exit delay
will be overrided to 5 seconds.
PART-ARM 1
The system can be set in PART-Arm 1 mode using
either the Remote Control or the Control Panel as
follows:
Remote Control:
Press the ‘PART-ARM’ button, .
Control Panel:
User Password
By pressing , the programmed exit delay will
be overrided to 5 seconds.
PART-ARM 2
The system can be set in Part-Arm 2 mode using either
the Remote Control or the Control Panel as follows:
Remote Control:
Press the ‘PART-ARM’ button twice, , .
Control Panel:
User Password
By pressing , the programmed exit delay will
be overrided to 5 seconds.
DISARM
The system can be Disarmed using either the Remote
Control or the Control Panel as follows:
Remote Control:
Press the ‘DISARM’ button,
.
Control Panel:
User Password
38
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro AP5500 - Pro Alarm System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro AP5500 - Pro Alarm System in the language / languages: English as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elro AP5500 - Pro Alarm System

Elro AP5500 - Pro Alarm System Quick start guide - English - 8 pages

Elro AP5500 - Pro Alarm System Quick start guide - German - 10 pages

Elro AP5500 - Pro Alarm System Quick start guide - Dutch - 8 pages

Elro AP5500 - Pro Alarm System User Manual - Dutch - 42 pages

Elro AP5500 - Pro Alarm System Quick start guide - French - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info