646319
28
Zoom out
Zoom in
Previous page
1/49
Next page
28 of 49
Commissioning
Safety check of heating appliance
Monitoring of the safety device
of the heating appliance
Checking the safety devices of the
boiler can be carried out using the
Flue Cleaner Key (8).
Press and hold the Flue Cleaner Key
(8) until the red LED (3) light is
illuminated then release immeadiatly.
Note: If the button is pressed for too
long i.e until the Red LED flashes with
a double flash then the boiler has
been put into Commissioning mode.
You will then need to reset and start
again.
Once in this mode the LED (3) will
flash and display will alternately flash
between "SF" and the boiler flow
temperature.
The boiler is now working at maximum
output in heating mode, and will
continue to do so until the safety
devices of the boiler are activated.
(On exceeding the temperature limit,
the appliance locks, the red LED (3)
flashes continually and the display
shows safety code 111.)
To resume operation, after cooling of
the appliance press RESET (6) key.
Protection system of heating
appliance
The boiler is protected from operating
faults by internal monitors in the
microprocessor circuit board, which
when necessary lock the appliance for
safety reasons. In the case of an
appliance being locked, a code is
shown on the display which gives the
type of locking and its cause. Two
types of locking can occur:
Safety Shut-Off
This type of fault is "temporary",
i.e. the fault is automatically
corrected, as soon as its cause is
corrected. Thereupon the
appliance switches itself on again
and resumes its normal operation.
While the appliance is in safety
stop, you can try to set it going
again by switching off and then on
again.
If safety switch-off occurs
repeatedly, please contact MHS
Service / Technical Support.
Locking
This type of fault is "Permanent",
the heating appliance can be reset
by pressing Key (6).
There follows a list with possible
operating messages and the
corresponding codes shown on the
display.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elco MHS - EURON 24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elco MHS - EURON 24 in the language / languages: English as an attachment in your email.

The manual is 2,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info