663873

EdgeCraft Chef-s Choice Trizor XV - EdgeSelect 15 Manual

7
Zoom out
Zoom in
Previous page
1/16
Next page
7
STROPPING/POLISHING THE EDGE IN STAGE 3
Pull the blade through the left slot of Stage 3 (see Figure 7) and then through the right slot of
Stage 3. Make 3 pairs of pulls, alternating each pull in the left and right slots. You should take
about 3 to 4 seconds for each pull for a 5 inch (12 cm) long blade.
Then make 2 pairs of alternating faster pulls in this Stage, about 1 second per pull for a 5 inch
(12 cm) blade to put a final polish on the edge.
Check the blade for sharpness. For a sharper edge make a few more pairs of fast pulls and
check for sharpness.
RE-SHARPENING EURO/AMERICAN AND CONTEMPORARY ASIAN BLADES
Re-sharpen following the Stropping/Polishing procedure in Stage 3 as described above.
Depending on its use, you should be able to re-sharpen to a razor sharp edge 3 or more times
using only Stage 3 before finding it necessary to again hone in Stage 2. Hone in Stage 2 only
when you find it is taking too long or too many pulls in Stage 3 to bring the edge to razor
sharpness. In that event, follow the honing and stropping/polishing sequence in Stages 2 and 3
as described above.
SHARPENING THE TRADITIONAL (SINGLE BEVEL)
JAPANESE BLADE
Traditional Japanese knives such as the sashimi blade shown here are single sided and have
a large factory bevel (see Bevel A, Figure 10c) on the front side of the blade. There are a large
number of manufacturers of knives of this type used widely to prepare sashimi. The factory
bevel (Bevel A) is commonly ground at about 10 degrees, but there are exceptions and that
angle is not standardized at the factories. Designs of the traditional Japanese knives and the
Figure 6. Honing in Stage 2 (left slot). Figure 7. Stropping/Polishing in Stage 3.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EdgeCraft Chef-s Choice Trizor XV - EdgeSelect 15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EdgeCraft Chef-s Choice Trizor XV - EdgeSelect 15 in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info