702458
10
Zoom out
Zoom in
Previous page
1/24
Next page
When all the instructions on the previous pages have been
completed, the machine can be installed into its operating
position using the Rollerjack
TM
handle (see section 01).
Using the Dyson spanner, adjust the two front feet so that the
machine is perfectly stable and is touching the ground on all
four corners and cannot rock.
Do not use wood, carpet or other material to stabilise the
washing machine.
After installation
Run an empty 60
o
C cotton cycle with a half measure of
detergent. For the correct dosage, please follow the
manufacturer’s instructions on the detergent packaging.
(See sections 01 and 01 on how to start the machine).
This will clean any test water out of the machine, and allow
you to check that the machine is installed and levelled correctly.
Observe it regularly during the first wash and check
connections afterwards and during the first week, to ensure
that they have been fitted correctly.
87
4
Cold water only supply
If there is no hot water supply, attach the cold and hot hoses
to the machine as normal. Then, attach both hoses to a
Y-piece (which can be bought from most DIY stores) and
finally connect the Y-piece to the cold inlet tap.
Once all connections have been made, turn on the tap(s) to
check that there are no leaks, tighten by hand if necessary.
Electrical installation
Warning: This machine must be earthed
Any electrical work required to install the washing machine
should be carried out by a qualified electrician.
Before using your machine, check that the plug and sockets
match, and check that the voltage in your home corresponds
to the machine’s voltage.
This information is on the rating plate (see section 01).
The machine should be plugged into an earthed socket
which can be switched on & off, and that is easily accessible
after installation.
•Do not use an extension cable or plug adapter.
If the supply cord or plug are damaged disconnect the
machine from the socket outlet immediately. The supply cord
must only be replaced by Dyson or its appointed agents, as
special purpose tools and service techniques are required.
If the plug supplied needs to be removed it should be cut off
and disposed of safely. Under no circumstances should the
severed plug be inserted into a socket outlet as this will
present an electric shock hazard.
European conformity information
This Dyson washing machine has been tested and conforms
to the following European Directives:
73/23/EEC Low Voltage Directive.
93/68/EEC CE Marking Directive.
89/336/EEC EMC Directive.
1
Installation
5 03
Y piece
8887_CRO2_OPS_INNERS.qxd 5/11/03 3:26 pm Page 8
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dyson CR02 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dyson CR02 in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info