702458
9
Zoom out
Zoom in
Previous page
1/24
Next page
Water supply
Drainage
Installation
Connect your machine to the water supply by hand, using the
hoses supplied. Only tighten by hand, do not use a spanner.
Do not use old hoses.
Ensure the water pressure is between 0.4 and 5 bar.
Do not:
connect the machine to a mixer tap.
Hot and cold water supply
Attach the blue inlet hose to the cold inlet tap and the red
hose to the hot inlet tap, and turn on water supply.
5 02
You can alter the direction of the drainage hose to the left
or right.
•To change the direction of the machine’s drainage hose,
squeeze open the retaining clip using a pair of pliers and
hold it open while you rotate the hose.
Ensure the hose is inserted properly before releasing the clip.
Thread the drainage hose through the hose hook and adjust
the protruding end to a distance of 30mm. The hose hook
has a small retention hole that can be used to secure the
hose in position.
Do not use the hose hook for under-sink connections.
When installed with a standpipe or under-sink connection,
ensure that the water outlet end of the drainage hose is no
lower than 450mm above ground level. Position the hose so
that none of it lies higher than 600mm above ground level
(refer to section 01 for position).
NB: Failure to comply with these dimensions could cause
the machine to malfunction.
5
*Note: CRO1 Flowcheck and Memory have grey leak protection inlet hoses
Drainage hose hook
Drainage hose
30mm
Stand pipe
8887_CRO2_OPS_INNERS.qxd 5/11/03 3:26 pm Page 7
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dyson CR02 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dyson CR02 in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info