612049
13
Zoom out
Zoom in
Previous page
1/36
Next page
5.5 Winding on the looper thread
Caution: danger of injury
Turn off the main switch.
The looper thread may be threaded for winding on only
when the sewing machine is switched off.
When winding on for sewing with no underlay material:
arrest the sewing feet in the up position (see chapter 5.10).
Thread looper thread as shown in the upper illustration.
Wind about 5 coils of looper thread clockwise onto the bobbin core.
Place bobbin 3 on bobbin-winder shaft 5.
Swivel bobbin-winder lever 4 against the bobbin.
The bobbin-winder wheel 2 is pressed against the V-belt.
Adjust tension 1.
The looper thread should be wound on with minimal tension.
Sew.
The bobbin-winder lever 4 terminates the process as soon as the bobbin is full.
5.6 Fitting the looper-thread bobbin
Caution - danger of injury
Turn off the main switch.
The looper-thread bobbin may only be changed with the
sewing machine switched off.
Removing empty looper-thread bobbin
Turn handwheel until the needle bar reaches its highest position.
Pull off cap 6 in the direction of the arrow.
Raise bobbin-housing flap 8.
Remove top 7 of bobbin housing with bobbin.
Remove empty bobbin from top 7 of bobbin housing.
Threading looper thread
Place full bobbin 11 in top 7 of bobbin housing:
when the thread is wound off the bobbin 11 must rotate in the direction of the arrow.
Draw looper thread down through slit 10 under tensioning spring 9. Pull about 8
cm of looper thread out of the top 7 of the bobbin housing.
Replace top 7 of bobbin housing.
Close bobbin-housing flap 8.
15
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler b69 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler b69 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info