612049
15
Zoom out
Zoom in
Previous page
1/36
Next page
5.7 Adjusting looper-thread tension
Caution: danger of injury
Turn off the main switch.
The looper-thread tension may only be adjusted with the
sewing machine switched off.
Adjusting
brake spring 1 (class 69-FA-373)
On subclass
69-FA-373
the brake spring 1 prevents the bobbin from "running on" when
the machine halts or if the looper thread is wound off spasmodically.
Unscrew regulating screw 4 until no tension remains in tension spring 3.
Adjust brake spring 1 with regulating screw 5.
The braking force is correctly adjusted if brake spring 1 is about 1 mm above
surface 2.
Adjusting tension spring 3
Adjust tension spring 3 with regulating screw 4.
to increase looper-thread tension: turn screw clockwise
to reduce looper-thread tension: turn screw anticlockwise
For stitch formation see sketch a on page 12.
5.8 Fitting and changing the needle
Caution: danger of injury
Turn off the main switch.
The needle may only be changed with the sewing machine
switched off.
Turn the handwheel until the needle bar 6 reaches its highest position.
Undo screw 7.
Pull needle downwards out of needle bar 6.
Insert new needle
as far as it will go
into the hole in needle bar 6.
Caution:
When seen from the operating side of the machine the furrow 8 of the needle must
point to the rights(see sketch).
Tighten screw 7.
CAUTION:
When a thicker needle is fitted the distance from the
shuttle to the needle must bed corrected (see servicing
instructions).
Failure to comply with this instruction can cause the following faults:
when fitting a thinner needle: faulty stitches, damage to thread
when fitting a thicker needle: damage to the shuttle tip and needle
17
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler b69 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler b69 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info