633970
10
Zoom out
Zoom in
Previous page
1/28
Next page
8
3.2.1
Threading of needle thread
Pass the needle thread according to fig. 9.
- through the reel stand,
- from right through the thread guide O,
- from right through the upper hole in the thread guide L,
- from left through the middle hole of the thread guide L,
- from right through the lower hole of the thread guide L,
- counter-clockwise around the adjustable needle thread pre-tension K
- back through the lower hole of the thread guide I,
- clockwise over the thread guide I,
- counter-clockwise in the adjustable needle thread main tension H, clockwise in the thread guide F,
up to the hook,
- from outside below the pulling spring D,
- from below behind the thread guide E,
- from below behind the adjustable thread guide G,
- from right through the lower hole in the thread take-up lever,
- from above through the thread guide E (if available),
- behind the thread guide C,
- through the thread guide R,
- to the hook through the needle and advance some 8,0 cm
Thread tension
3.3
3.3.1
Adjusting the thread tensions
Rule 1:
A good seam pattern with regularly tightened stitches is often obtained only by regulating the needle
thread tensioning elements, principally by the needle thread main tension H.
Indication 1:
When adapting the needle thread tension, loosen first the needle thread pre-tension K and regulate only
the needle thread main tension H, until the bobbin thread and the needle thread are locked in the material,
fig. 5.
The needle thread pre-tension should be regulated finally, because it is always lower than the main
tension of the needle thread.
Rule 2:
In case of a general adjustment of the thread tensioning elements, adjust first the bobbin thread tension P
for a low value and adapt it then to the needle thread tension.
Indication 2:
For a lockstitch seam, the low bobbin thread tension can already be influenced during the winding
process by the adjustable bobbin winder pre-tension P. The bobbin thread pre-tension P should be
adjusted so that the bobbin thread is wound regularly with the lowest possible tension.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 267 - 2016 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 267 - 2016 in the language / languages: English as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info