801276
25
Zoom out
Zoom in
Previous page
1/72
Next page
Instructions for use ST4D 2G / ST4D 2G PLUS
25
Drive Medical GmbH & Co. KG | As per: 04.05.2020 | Errors and alterations excepted
EN
Transport
Use a ramp to load the scooter. If necessary, you can
also lift the scooter over a step or the like. At least two
people are needed to do this. Lift the scooter only at
fixed parts of the frame, in the front and rear under the
cladding. For safety reasons, the scooter may be lifted
only WITHOUT the user.
Do NOT remain seated in your scooter when the scooter
is being transported in a vehicle. Always secure your
scooter and use a seat in the vehicle.
Exception: Taking your scooter with you in public trans-
port buses.
Storage
Ensure that the electric scooter is switched o and
stored with the battery removed and the charging unit
unplugged. Store the electric scooter in areas protected
from direct sunlight, water, and humidity.
Cleaning | Disinfection
Clean regularly with a moist cloth!
Do not use any aggressive cleaning agents!
Do not use abrasive cleaners!
Do not use any high-dose chlorine and vinegar-based
cleaners!
To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
Check the screws regularly and tighten, if necessary.
The product must not be continuously exposed to
temperatures over 60°C.
In the event of defects, contact your specialist dealer
from whom you purchased this product.
Do not use any petroleum ether, solutions or evapo-
rating solutions since these could damage body parts.
Ensure that the charging unit was removed and that
the electric scooter is switched o before you clean it.
Do not park your electric scooter under wet or damp
conditions since this leads to mold growth and a rapid
deterioration of the cushioned parts.
Problem Cause Remedy
Electric scooter cannot
be switched on Batteries not connected
Circuit breaker/overload switch was triggered
Check battery connection
Press circuit breaker to reset
Electric scooter can be
switched on but does
not drive
Defective batteries
Charging unit is inserted
Motor is in neutral
Charge/replace battery
Remove charging unit from the electric
scooter
Put neutral lever into “Drive”
Electric scooter drives
slowly Weak batteries
Speed is set to low
Charge battery
Select higher speed
The seat moves during
operation The seat is not properly snapped into place Rotate the seat slowly until it snaps
into place and is secured (see section
entitled "Seat”).
The steering column
appears to be loose or
does not freely swivel
The fixing screws for the steering column are
loose
Tighten the fixing screws for the steering
column
Horn sounds
unintentionally or
automatically
The electric scooter has diagnosed an error Ensure that the control lever is not
operated and switch the electric scooter
o and on.
Charge the batteries if the problem
persists.
Troubleshooting
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Drive ST4D 2G PLUS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Drive ST4D 2G PLUS in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 6.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info