768203
32
Zoom out
Zoom in
Previous page
1/44
Next page
R699890 - Siglos X-tra Series User Manual
MAINTENANCE
32
16.0 MAINTENANCE
16.1  Cleaning and Replacing the Dust Filters
The lters must be cleaned regularly to allow an efcient air intake. Otherwise, dirt may enter the unit and appear
on the screen, preventing you from enjoying the video fully. If dirt has entered the unit or if you need information
about the lter, please consult your authorized dealer. A lter cleaning warning appears every 500 hours.
Cleaning procedure
Pull out the power plug from the outlet while the projector is in standby mode.
Push up and lift the claw of the lters, pull out the lters.
Clean the lters with water and dry them, avoiding direct sunlight. In extremely soiled cases, use of a neutral
detergent is recommended. Insert the lters in their original positions and make sure that the claws are rmly
inserted.
Dust Filter
16.2  Dirt on the Lens
The lens shall be cleaned using commercial blowers or lens cleaning papers (for cleaning glasses and cameras).
Do not use uid-type cleaning agents. This may lead to peeling of the surface coating lm. The lens surface is
fragile. Avoid rubbing it hard or knocking.
16.3  Replacing the Lamp
Light-source Lamp and Lamp Usage Time
The life of light-source lamps used for this unit is about 4500 hours when running this unit in low lamp power
mode.
When the lamp power is set to Low, the lamp life is approximately 4500 hours. This average lamp life is not
guaranteed and may not reach 4500 hours depending on the operating conditions. Get ready or replace with
a new lamp when the accumulated usage time exceeds 4500 hours. Depending on the operating conditions,
the lamp may have to be exchanged earlier. If the image is dark or if the color tone is abnormal, replace the
lamp as soon as possible.
When the lamp life time exceeds 2900 hours, a warning message is displayed, press the [BACK] button to
clear it and replace the lamp before the lifetime reaches 4500 hours.
ABOUT LAMP REPLACEMENT
If this unit is installed in a constricted place, attempting to replace the lamp in that place may cause injury.
Use only genuine replacement parts for the lamp unit. Otherwise, malfunction may occur.
Do not replace the lamp immediately after this unit has been used. The temperature of the lamp is still
high and this may cause a burn. Allow a cooling period of 1 hour or more before replacement.
Before replacing the lamp unit, pull out the power plug from the outlet and wait until the STANDBY/ON
led is still light red.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DreamVision Siglos X-TRA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DreamVision Siglos X-TRA in the language / languages: English as an attachment in your email.

The manual is 4,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info