554450
39
Zoom out
Zoom in
Previous page
1/58
Next page
39
and right pegging points are at the same height from the ground.
6) If you are using the Quick Lock pads, it is now time to fix them at
the correct position. For further instructions of the use of these we
would like to direct you to page 35 where detailed instructions of
the Quick Lock pads are described.
7) Now start to sort the frame and spread out the main sections
according to the frame diagram. Clamps can now be assembled
onto the frame
8) The centre angle should now be placed at a sloping angle under-
neath the awning. Now, take a roof rafter and attach the hook into
the plastic eye or the Quick Lock pad. Attach this roof rafter into
the centre angle now. Take one of the two corner sections included
with a leg rafter and attach this with the centre angle. Like the centre
roof rafter, you should now attach the hook into the plastic eye or
the Quick Lock pad and attach this roof rafter with the corner an-
gle. For the opposite corner angle you follow the same procedure.
(In case of a 350 cm deep awning, the frame of the porch area
should now be erected first). Insert the short canopy stubpoles into
the centre angle and the two corner angles. In case your awning is
provided with canopy roof poles (these are the frame parts fixed
crosswise onto the canopy stub poles) you should now slide them
through the fitted sleeves in the canopy, after which you can place
them on top of the spikes of the small canopy stub poles.
9) Now, put all the front and side panels back into place and close all
zips. With the models that have L shaped side panel zips it is very
important to close all buckles first, before you zip it back in. This will
prevent damage to the zip and the stitching.
10) Commence tensioning the canopy stub poles. Tension these so
that the front roof poles only just touch the fabric on the inside
of the awning canvas. Tighten the clamps carefully to prevent the
frame sections from sliding into one another. Tension the front po-
les crosswise making sure that the centre angle stays positioned
exactly in the middle of the intended opening in the awning. By
temporarily moving the corner leg rafters into a sloping angle
or slightly reduce the height, tensioning the front poles crosswi-
se will become much easier. (For a proper sequence in case of
350 cm deep awning you should start with the frame of the
porch area first and with the main frame afterwards). Start ten-
sioning the roof rafters now. Adjust all the upright poles so that
ERECTING YOUR AWNING
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dorema Voortent-Luifel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dorema Voortent-Luifel in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info