5
The more medicines you store in the refrigerator then
reduces the hazard of freezing, if the unit has a short
period of time undercooling.
We take no responsibility for damage to vaccines
through freezing, if there has been a cutout in the
electricity for a short period of time.
The temperature readings may rise temporarily after
opening the door or placing additional items inside the
cabinet.
It is important to reset the thermometer regularly to
ensure that the temperature is maintained between 2 °C
and 8 °C.
On the battery transit strip must be removed to activate
the temperature display.
Figure 2.
7. Useful suggestion
The appliance is equipped with a fan in order to have a
uniform inner temperature. The fan is operating only if
the door is closed. At a door opening the fan will stop,
then it starts again working when the door is closed.
If the fan incidentally stops, and the door of the
appliance is closed, the electronincs will emmit an
audible warning signal (continouos signal)
Audible warning signals to tell the customer to close the
door: If the door is kept open for more then 20 s, the
electronics emmits an audible warning signal (intermitent
signal with beeping frequency of 1 Hz), then after
another 40 s it emmits another audible warning signal
(intermitent signal with beeping frequency of 2 Hz).
Do not overfill the appliance. It is advisable to leave
some space between the products in the cabinet to
ensure efficient and even cooling. If the shelves are
packed too tightly there may be unacceptable
temperature variations.
8. Defrosting, cleaning and
maintenance
Frost will gradually form on the cooling surfaces and it
must not be allowed to become too thick since it acts as
an insulator and interferes with the cooling.
We recommend to defrost the appliance in every 3
weeks, or depending on the ice quantity on the cooling
fins. While defrosting the appliance should be switched
off by disconnecting the refrigerator from the electricity
supply and leave the cabinet door open.
GB
4. Positioning the appliance
When first using this refrigerator please consider the
following points:
ENSURE REFRIGERATOR IS LEVEL
THE PIPEWORK AT THE BACK GETS HOT IN USE
THE REFRIGERATOR HAS NO 'MOTOR' AND IS
THEREFORE VIRTUALLY SILENT
ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING
During the refrigeration process, the appliance gives
off heat from the condenser (under the upper part of
the rear cover) into the surrounding air. The more ventilated
the condenser is, the more effective the refrigeration will
be.
The other condition for satisfactory operation is that the
appliance stands on a flat surface. This is best seen by
placing a glass of water on top of the appliance.
It is important that the appliance is not directly exposed
to radiated heat (sunlight, radiator, near an oven, etc.).
Please do not place the refrigerator onto thick carpet!
4.1. Installation instructions
This version is supposed to be freestanding. Cooling unit
room cover protects from the hot parts of the cooling unit.
Foot frame with grilles ensures sufficient ventilation.
5. Using the appliance
To start the refrigerator connect the plug to the socket
outlet and switch on the socket. The cooling fins should
show signs of cooling after about 1-2 hours depending on
ambiant temperature.
5.1. Initial operation
The device must be plugged into a properly earthed
socket.
The miniCool starts automatically with a self-test. The
LED illuminates after plugging-in several times and after
that continuous light can be seen if the door is open.
The miniCool achieves its operating temperature after
several hours.
5.2. Temperature regulation
The Health Care refrigerator is fitted with a fully automatic
electronic temperature regulator. It is not needed to set the
temperature of the storage compartment manually.
6. Thermometer (Fig. 2)
Refer to the separate instruction leaflet supplied with the
thermometer. The thermometer can be stood up using the
attached stand or alternatively it can be fixed to the
refrigerator door, in which case the sensor wire should be
arranged so that it is not stretched or damaged when the
door is opened.
The temperature sensor is located inside the refrigerator
below the bottom shelf.
The display will then show the current, maximum and
minimum temperature inside the refrigerator.
After the first pull down of the refrigerator (allow four hours)
please make a "reset" on the thermometer because
otherwise it will keep as "maximum" the ambient
temperature.
FERRITE ring
