507652
16
Zoom out
Zoom in
Previous page
1/136
Next page
16
2. Cleaning of air cleaner
WARNING
INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection: Daily (every 10 operating hours)
(1) Loosen the knob bolt.
(2) Remove the air cleaner cover.
(3) Take out the element and remove any dirt with the brush.
Note: The element is a dry type and should not get wet. Never wash with
water.
(4) Replace the element with a new one if it is damaged or very dirty.
Part No. 6676500201: ELEMENT AIR CLEANER
(5) Wipe off any oil that has come in to contact with the breather with a rag
or cloth.
(6) Install the element in the cleaner case.
(7) Attach the air cleaner cover and tighten the knob bolt.
3. Checking the spark plug
(1) Opening/closing the plug cover
To open the plug cover, pull up on the seam of the plug cover projection
and slide in the direction of the OPEN indication as shown in the figure
at right.
When closing the cover, slide the cover in the CLOSE direction till the
click under the plug cover projection rides over the engine cover. Finally,
push in the projection.
(2) Removing the spark plug
Use an attached box wrench to remove or install the spark plug.
(3) Checking the spark plug
The clearance between two electrodes of spark plug (see the figure left)
is 0.7 to 0.8 mm. Adjust to the correct clearance when it is too wide or
too narrow.
Clean thoroughly or replace the spark plug if it has accumulated carbon
or contaminated.
(4) Replacing the spark plug
For replacement, use NGK-CMR6A.
DANGER
Clean the element several times a day, if excessive dust adheres to it.
If operation continues with the element remaining not cleared of oil, oil in the air cleaner may fall outside, resulting in oil contamination.
CAUTION
When removing the spark plug, clean the spark plug and cylinder head first,
so that no dirt, sand, etc will enter the cylinder.
You must remove the spark plug after the engine has cooled down in order to
avoid damaging the threaded hole in the cylinder.
The spark plug must be installed properly into the threaded hole. If installed at
an angle, the threaded hole in the cylinder will get damaged.
Element
Knob bolt
Element cover
Breather
Lateral electrode (-)
Electrode clearance
0.7 - 0.8 mm
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar PB-7600.4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar PB-7600.4 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 3,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info