507649
16
Zoom out
Zoom in
Previous page
1/28
Next page
16
Carburetor adjustment is necessary for optimum engine
performance, for safer and more economical operation. The
engine should be warm, the air Þ lter clean, and the chain
properly tensioned. Have carburetor adjustment done by
an authorised DOLMAR service centre.
The carburetor is factory-adjusted for the air pressure at sea
level. At other elevations or under other conditions of weather,
temperature, or humidity, or when breaking in a new engine, it may
be necessary to make slight adjustments to the carburetor.
You will need a tachometer (1, part No. 950 233 210) for
optimum adjustment.
Do not go below the speciÞ ed setting of the main nozzle
(H). Doing so may cause engine damage due to overheating
and insufÞ cient lubrication!
Use the supplied carburetor screwdriver (2) for carburetor adju-
stment. It has a moulded-on projection that aids in adjusting.
Before undertaking the adjustment, run the engine for 3-5 mi-
nutes to warm it up, but not at high speed!
For proper adjustment, proceed as follows:
1. Basic setting (engine off)
Start engine and warm up.
2. Set idle
3. Check acceleration
4. Check top speed
5. Check idle speed
Repeat steps 2-5 until you get the right idle speed, good
acceleration and maximum permissible
1. Basic setting
Carefully turn the adjusting screws for the main nozzle (H)
and idle nozzle (L) clockwise until you feel a stop.
Turn adjusting screws (H) 1
1
/
2
and (L) 1
1
/
2
counter-clockwise.
2. Set idle
Set the idle speed per the technical speciÞ cations.
Turning the adjusting screw (S) in (clockwise) increases the
idle speed. Turning it out (counter-clockwise) lowers the idle
speed. In no case should the chain move.
3. Check acceleration
When the throttle is pressed, the engine should go smoothly
from idle to high speed. If this is too slow, turn the adjusting
screw (L) in small (max. 1/8 turns) increments counter-clo-
ckwise.
4. Check top speed
The basic setting H=1
1
/
2
and L=1
1
/
2
gives a maximum speed
of about 13,500 rpm.
For higher speed (electronically limited ), turn the adjusting
screw (H) a maximum 1/4 turn clockwise.The top speed
in the governor can be clearly heard from the ignition mis-
ses.
Note: Since there is an electronic speed governor (limiter)
at 13,500 rpm that cuts off the ignition current, the top speed
cannot be read from the tachometer.
Important: To prevent engine damage, never go below
setting (H) 1
1
/
4
turns.
5. Check idle speed
Check the idle speed after setting the top speed (the chain
must not move).
Repeat the adjustment procedure starting at Step 2, until the
engine runs with the correct idle speed, good acceleration,
and top speed.
E
1
2
Adjusting the carburetor
(only for not EU-countries)
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar 115 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar 115 in the language / languages: English as an attachment in your email.

The manual is 3,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dolmar 115

Dolmar 115 User Manual - German - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info