766054

Dogtrace d-control 1600 Manual

13
Zoom out
Zoom in
Previous page
1/23
Next page
13
Reprogramming of your receiver
The receiver can be programmed repeatedly without restraint using the same transmitter
or another (see the section Programming (pairing) of the transmitter and the receiver).
Choice of the contact points
The stimulation is transferred on your dog‘s skin through the steel contact points of the
receiver. Each set contains 2 types of contact points. Sucient length of the contact points
has to have a contact with the dog‘s skin, enabling the device to operate correctly. If you
have a short-haired dog use the 12 mm contact points, if you have a long-haired dog
replace them with the longer 17 mm contact points supplied in the kit. Screw the contact
points onto the screws of the receiver - see the picture: Receiver in the chapter Product
description. Tighten them manually and carefully (do not use a key – this could damage the
product).
Fitting the collar
The strap with the receiver (receiver collar) must be tightened enough so that the contact
points are in contact with the skin of the dog. We recommend you to t the collar on the
standing dog. When you can t two ngers between the collar and your dog‘s neck, the
collar with the receiver are tightened enough. If a dog has long or thick hair, it is suitable to
Example: Button is paired with 3 receivers, they can be programmed one by one or
we can set all 3 in pairing regime and then press button for audible beep tone. All these
receivers will perform the same action at the same time when pressing function button.
This can be used for two collars on the neck of one dog, or for the training of higher
number of dogs, where we give the same commands to all of them at the same time.
TIP: If your dog has very long hair, you can order 21 mm long contact points. When
your dog has a dry skin in the area where the contact points are, it is good to lubri cate
the dog‘s skin with a vaseline, hand cream, or baby oil - which enables a correct
transfer of stimulation impulses.
TIP: It is possible to program an unlimited number of receivers to a one transmitter.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control 1600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control 1600 in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info