766054

Dogtrace d-control 1600 Manual

11
Zoom out
Zoom in
Previous page
1/23
Next page
11
Receiver preparation Switching the receiver ON/OFF
To turn the receiver ON/OFF ( or for programming the transmitter with the receiver) is used
a magnetic switch, marked with the red target on the receiver. The receiver is activated
when the magnet in bottom of the transmitter, is enclosed to the red target on the receiver.
Switching ON
Move the red target of the receiver towards the bottom of the transmitter for 1 second
(see the Fig.). The red LED indicator of the receiver will lit up, afterwards the green LED
indicator will start blinking. The receiver is prepared for use.
Switching OFF
When switching OFF, follow the same steps as when switching ON.
Move the red target of the receiver towards the bottom of the transmitter - the green LED
indicator of the receiver will lit up, afterwards the red LED indicator will lit up.
Caution: To extend the battery life, it is necessary to turn
o the receiver and transmitter whenever the training of
your dog is  nished. If you do not use the device for a
long time, we recommend you to remove the batteries
out.
IMPORTANT: When turning the receiver ON hold
the red target of the receiver close to the red target
of the transmitter for about 1 second. When the
targets are close to each other for longer than
5 seconds the receiver will switch to the pairing
(programming) mode of the transmitter with the
receiver. This programming mode is indicated by
alternate  ashing of the red and green LED indicator.
If this occurs, follow the chapter Programming
(pairing) the transmitter with the receiver.
The position where the receiver
is turned ON/OFF and where
the transmitter is being paired
with the receiver.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control 1600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control 1600 in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info