766054

Dogtrace d-control 1600 Manual

12
Zoom out
Zoom in
Previous page
1/23
Next page
12
Programming (pairing) of the transmitter and the receiver
Each transmitter has its own RF operational code. The pairing needs to be done to make
the receiver and transmitter operate together. When you receive a new set the pairing is
done by manufacturer. The pairing is done, when you need to use dierent transmitter
or receiver (for example when bought a new one).
The transmitter is made for training of two dogs, so you can pair it with two receivers. Use
the buttons / to choose the right dog.
Pairing of the button with the rst receiver
1. Turn ON your transmitter.
2. The receiver has to be turned OFF.
3. Press the button for the rst receiver choice.
4. Move the lower part of the transmitter to the target on your receiver (see the Fig. on
page 11) and hold in position so the green LED is steadily lit. After approximately
5 seconds it will switch to the pairing /programming mode, indicated by ashing of
the red and green LED at the same time (4x).
5. Then take your transmitter away from the receiver and press down the audible beep
tone button on your transmitter. If you hear the beep tone the pairing has been
successful.
Pairing of the button with the second receiver
Press the button for the second receiver choice and follow the steps as for the rst
receiver above (this can be followed when you use d-control 600, 1000 or 1600 with a
new purchased receiver or when you purchased d-control 602, 1002 or 1602).
IMPORTANT: Before programming is started make sure that no one else uses his/her
d–control in your neighbourhood. Your receiver could randomly receive the code
from another transmitter and get paired with it. If this happens, program your receiver
once again, using your transmitter.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control 1600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control 1600 in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info