652870

Dittmann TGS 440 Radio Tens Device Manual

16
Zoom out
Zoom in
Previous page
1/29
Next page
Figure 6
Figure 7
Figure 8
Figure 10
Figure 9
Figure 11
Step 5
Now, apply the adhesive electrode pad (Figure 10 - Example)
or both adhesive electrode pads (Figure 11 - Example) with
the TENS stimulator connected on the skin. In this respect,
please ensure that each adhesive electrode pad is fully applied
onto the skin area to be treated so as to make sure that the
entire surface of the electrode is in proper contact with the
skin. Whenever possible, apply the adhesive electrode pads on
flat and not on uneven or rounded areas of the skin in order to
ensure that full contact with the skin is ensured. Application
examples on the correct positioning of the adhesive electrode
pads can be found on page 21 and 22.
Attention! The device must not have been switched on while
the adhesive electrode pads are applied!
Step 4
The adhesive electrode pads should only be applied on clean,
greaseless and dry areas of the skin. Grasp the adhesive
electrode pad in the area of the arrow with the "PULL" imprint
and remove it carefully from the protective foil. Please make
sure that you do not touch the adhesive surfaces with your
fingers (see Figure 9).
Attention - Observe the safety instructions! After the therapy
session has been completed, stick the electrode pads back onto
the protective foil.
Step 3
Using the two press stud connections, fasten an adhesive
electrode pad to the TENS stimulator A and fasten another
adhesive electrode pad to the TENS stimulator B if you wish to
use both TENS stimulators at the same time. In this respect,
make sure that the adhesive electrode pads are securely
connected to the TENS stimulators by means of the two press
stud connections (see Figure 8).
Attention! At this point, the TENS stimulators must not have
been switched on yet! Please ensure that you do not press
unintentionally on the (+) key of the TENS stimulators when
connecting the adhesive electrode pads!
Step 2
Insert two 1.5 V batteries (type AAA) observing the correct
polarity (+ (positive) and - (negative) pole) in the remote
control and in the TENS stimulators (see Figure 7 and
description in Chap. 7.0 on page 13-14).
Step 1
Prior to starting a therapy session, carefully clean the skin
areas in the application area using water and soap and dry it
well afterwards (see Figure 6).
9.0 Commissioning of the radio TENS device
COMMISSIONING / USAGE
16
GB
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dittmann TGS 440 Radio Tens Device at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dittmann TGS 440 Radio Tens Device in the language / languages: English as an attachment in your email.

The manual is 2,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info