798170
43
Zoom out
Zoom in
Previous page
1/52
Next page
www.dimplex.eu 2007/A EN-17
Electrical connection English
7.12 Reinsert the core room cover.
Left: The upper edge (A) of the core room cover must
rest on the partition. Slide the lateral edge (B) behind
the bevel of the partition.
Right: Insert the lateral edge of the core room cover
(C) between the thermal insulation and the partition.
Watch out for the guiding slots.
Press the core room cover firmly and fix in place with
the three screws.
8. Electrical connection
CAUTION!
When connecting the storage heater to the
power supply, the relevant VDE, EN and IEC
standards must be observed. The technical
connection conditions of the energy supplier
or grid operator must be complied with.
NOTE
There must be an all-pole disconnecting device up-
stream of the device with a distance of at least 3 mm.
This requirement is met via circuit breakers, for exam-
ple.
8.1 Fold the main electronics down by 90° (A) to ac-
cess the connecting terminals.
Insert the electrical connecting lines and provide
strain relief. (B). Shorten the lines so that they do not
touch any hot device surfaces during operation. Do
not route any cable loops behind or below the device!
NOTE
When folding up the main electronics into the vertical
position, ensure that no lines are trapped.
Circuit diagram and connecting terminals can be
found on the next page.
NOTE
T
ake care to apply appropriate torque to screws, max-
imum 1.2 Nm.
A
B
C
A
B
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex VFE50K at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex VFE50K in the language / languages: English, German as an attachment in your email.

The manual is 4.11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info