Manual Dik Geurts Vidar Triple-wall (page 30 of 76) (English, German, Dutch, French)

695365

Zoom out

Zoom in

1/76

English

INSTALLATION MANUAL

5.5.3 Built-in fires

Determine the place of the fire.

Slide the build-in frame into the desired position.

Use non-combustible and heat-resistant material according to European fire classification A1 EN 13501-1 for the

plate on the floor, chimney breast (including the upper face), the material in the chimney breast and the back wall

against which the appliance is fitted. Plate material or stony materials can be used for this.

If there is a flammable ceiling, place a fire-resistant plate with a 10 cm thick heat-insulating layer on top 30 cm

below the ceiling in the chimney breast.

Place the fire level at the desired height and fix it with metal anchors.

Connect the flue duct to the fire ring.

Always connect any convection openings with heat-resistant flexible pipe and ventilation elements to protect the

plasterwork against high temperatures. If the chimney breast is made of non-combustible materials (e.g. facing

brickwork) this is not required.

Make sure there is sufficient space under the fire for the supply of combustion air. When the outside air

connection ring is not used, it must remain at least 20 mm free for sufficient combustion air.

If applicable connect the outside air connection (see section 9 'Appliance-specific information').

The fire is not suitable to support a flue duct, it must be self-supporting.

Stony materials may absolutely not rest on the fire. For this use e.g. a brick lintel with ceramic felt.

Make sure that the opening in the chimney breast is 6 mm wider than the built-in frame.

The chimney breast may not be warmer than 90 degrees Celsius on the outside;

Lay a fire-resistant floor plate for the fire if the floor is flammable. The floor plate in non-flammable material must

extend at least 300 mm away from the fire and be at least 300 mm wider than the fire.

5.6 Completing installation

Check if grit, dust or other materials are left behind in the chimney breast (odours).

Use clean fabric gloves and avoid fingerprints on the fire and flue pipes.

Check whether the interior lining and the baffle plates are fitted properly in the fire (if applicable see section 9

'Appliance-specific information'). Correct the position of these plates if necessary.

Check whether the holes of the secondary ventilation in the back plate are immediately facing the recesses in the

interior lining.

Clean the fire with a soft cloth and check it for damage. The fire can be sprayed with the spray can supplied.

Before doing this read the instructions for use on the label. Always first check the colour on a piece of white paper

or cardboard before you treat the fire.

First carefully read the user manual before starting to use the fire. We refer to the user manual for lighting and

burning the fire.

6. Delivery

You must make the user familiar with the fire. Among other things you must instruct her/him about bringing the

fire into use and its burning and maintenance.

When bringing into use point out that

- after rebuilding or new building all building materials must have thoroughly dried out to avoid dust

(including smoke particles) adhering to damp surfaces;

- the first time of burning volatile components will evaporate from paint, materials etc.;

- the space must then be well ventilated.

Point out the necessity to have the flue duct inspected and cleaned at least once a year by a specialist.

Give the user the user manual and installation manual (the installation manual must be kept with the appliance).

7. Maintenance

The user manual includes a number of tips/instructions for maintenance of the fire. It also mentions how a

number of parts can be replaced.

8. Malfunctions

The user manual contains a table with a summary of malfunctions that can occur, their possible cause and the

solution.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dik Geurts Vidar Triple-wall in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,05 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dik Geurts Vidar Triple-wall

Dik Geurts Vidar Triple-wall User Manual - English, German, Dutch, French - 64 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dik Geurts Vidar Triple-wall Manual

Product: