695335

Dik Geurts Prostyle 600 Manual

34
Zoom out
Zoom in
Previous page
1/76
Next page
English
INSTALLATION MANUAL
9.4 Glass pane
!Caution
- Avoid damage when removing/fitting the glass pane;
- Avoid/remove fingerprints on the glass pane because these burn in.
Tip!
Use the supplied pane window cleaner to remove fingerprints/dirt on the glass pane.
9.4.1 Disassembly of glass pane in door
To remove the glass pane in the door follow the instructions below:
Ø
Open the door.
Ø
Lift the door out by first sliding it upwards, then tilt it slightly forwards and allow it to lower.
Ø
Place the door on a flat surface.
Ø
Remove the nuts from the strips.
Ø
Remove the strips.
Ø
Lift the glass pane out. The pane seal is then also taken out.
Tip!
- When replacing the glass pane always replace the seal in the door (= seal between the glass pane and the
door).
- Check the door sealing cord and replace if necessary (see paragraph 9.3).
9.4.2 Assembly of glass pane in door
Assemble the glass pane in the door according to the steps described in paragraph 9.4.1 ‘9.4.1 Disassembly of
glass pane in door’ but in reverse order.
!Caution
Assembly of the door is somewhat different.
Proceed as for assembly of the door:
Ø
Bring the hole at the bottom of the hinging part of the door exactly below the lower pin.
Ø
Slide the door up. The pin slides into the lower hole.
Ø
Bring the hole at the top of the hinging part of the door exactly above the upper pin and allow the door to lower.
The pin slides into the upper hole.
Ø
The door is now assembled.
!Caution
- Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.
- Place the glass pane (including new pane seal) with the logo to the bottom right.
9.5 Frames
The appliances can be fitted with various frames. The frames are adjustable in depth and can be fitted so they are
parallel to the door.
!Caution
The installation depth of the appliance depends on the selected frame (see Annex 2, fig. 1)!
When assembling the frame proceed as follows:
Tip!
First remove the door before assembling the frame.
In-built frame (no frame):
Ø
Remove the 4 pre-assembled bolts/nuts (see Appendix 2, Fig. 12).
Ø
Slide the frame over the stove into the desired position (see Appendix 2, Fig. 13).
Ø
Fasten the 4 bolts and nuts (the bolts on the inside, the nuts on the outside of the appliance)
(see Appendix 2, Fig. 14).
Ø
Fasten the 2 bolts and nuts on top of the appliance (see Appendix 2, Fig. 14).
Other frames:
Ø
Loosen the 4 pre-assembled bolts (see Appendix 2, Fig. 15).
Ø
Slide the frame in the convection casing between the loosened bolts and the bolts still tight in the appliance
(see Appendix 2, Fig. 16).
Ø
Tighten the nuts. The frame is now clamped between the nuts (see Appendix 2, Fig. 17).
9.6 Supplementary installation instructions per appliance
The adjustable feet of the Instyle 600 EA and 650EA and the Prostyle 600EA and 650EA models are adjustable from
inside. On these adjustable feet there is a hexagonal nut that is adjusted with an open-end spanner.
UK
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dik Geurts Prostyle 600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dik Geurts Prostyle 600 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2.66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dik Geurts Prostyle 600

Dik Geurts Prostyle 600 User Manual - English, German, Dutch, French - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info