712289

DeWalt DCMW564 Manual

44
Zoom out
Zoom in
Previous page
1/184
Next page
42
ENGLISH
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
thetool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed ofproperly.
TROUBLESHOOTING
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local
DeWALT
repairagent.
WARNING: Before proceeding, release the bail bar to turn
mower off and wait for the blade to stop.
Problem Possible Solution
Mower doesn’t run
when bail handle
is activated
Check to make sure mower battery is properly
installed and that the button on switch box is
being completely depressed before pulling the
bail handle.
Release bail handle to turn mower off. Remove
safety key and battery pack, turn mower over and
check that blade is free to turn.
Check that the battery cavity is free of debris and is
connected properly.
Has battery been fully charged? Press state of
charge button.
Motor stops
while mowing
Release bail handle to turn mower off. Remove
safety key and battery pack Turn mower over and
check that blade is free to turn.
Raise cutting height of wheels to highest position
and start mower.
Check that the battery cavity is free of debris and is
connected properly
Has battery been fully charged? Press state of
charge button
Avoid overloading the mower. Slow down the
cutting pace, or raise the cut height.
Mower runs but
cutting performance
is unsatisfactory
Release bail handle to turn mower off. Uninstall
power source. Turn mower over and check:
• Blade for sharpness - Keep blade sharp.
• Deck and discharge chute for clogging.
Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
Mower is too hard
to push
Release bail handle to turn mower off. Uninstall
power source. Raise cutting height to reduce deck
drag on grass. Check each wheel for free rotation.
Problem Possible Solution
Mower is abnormally
noisy and vibrates
Release bail handle to turn mower off. Uninstall
power source. Turn mower on side and check
blade to ensure it has not been bent or damaged.
If blade is damaged, replace with a
DeWALT
replacement blade. If the underside of the deck is
damaged, return mower to a
DeWALT
Authorised
service centre.
If there is no visible damage to the blade and the
mower still vibrates:
• Release bail handle to turn mower off.
• Unplug mower.
• Disassemble entire blade assembly as described
in the Removing and installing
blade section.
• Remove any debris and clean each piece.
• Replace each piece as described in
the Removing and installing
blade section.
If mower still vibrates, return the mower to an
authorised
DeWALT
service center.
Battery charger LEDs
not on
Check plug connection.
Replace charger.
Mower not picking up
clippings with bag
Chute clogged. Release bail handle to turn
mower off. Uninstall power source. Clear chute of
grass clippings.
Raise cutting height of wheels to shorten length
of the cut.
Bag full. Empty bag more often.
… 44 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeWalt DCMW564 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeWalt DCMW564 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 21,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info