Manual DeWalt DCMW564 (page 41 of 184) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

712289

Zoom out

Zoom in

1/184

ENGLISH

removing/installing attachments or accessories. An

accidental start-up can causeinjury.

Installing and Removing the Battery Packs

(Fig. H)



DANGER: MAKE CERTAIN THE SAFETY KEY IS

REMOVED TO PREVENT ACTUATION BEFORE

REMOVING OR INSTALLINGBATTERY.

This mower is designed to operate on two battery packs of

equal capacity. The mower will not operate on a single battery

pack, and If using different capacity battery packs, the smaller

capacity battery pack, when depleted, will cause the unit to

turn off

NOTE: For best results, make sure each battery pack is

fullycharged.

To Install Battery Packs

1. Lift and hold the battery port cover

9

up to expose the

battery ports

23

2. Slide a battery

16

into each of the two battery ports until

an audible click is heard (Fig. H). Make sure the battery packs

are fully seated and fully latched into position.

3. Close the battery port cover. Ensure the cover is fully closed

before startingmower.

To Remove Battery Packs

1. Open the battery port cover

9

as describedabove.

2. Depress the battery release button

15

on the battery pack

and pull battery pack

out of tool.

READ THIS INSTRUCTION MANUAL BEFORE

OPERATING YOUR MOWER

Refer to Figure A at the beginning of this manual for a complete list

ofcomponents. Save this manual for futurereference.



DANGER: Sharp moving blade. Do not operate the

mower in mulching mode if the rear door is not closed

under spring tension as serious injury could result. Take

your mower to the nearest service centre forrepair.



DANGER: Do not operate mower unless handle is

locked into position.



DANGER:

Sharp moving blade. Never operate the

mower in bagging mode unless the hanger hooks on the

grass catcher are seated properly on the mower and the

rear discharge door rests firmly against the top of the grass

catcher as serious injury couldresult.



WARNING: Let the mower work at its own pace. Do

notoverload.

Adjusting Mower Height (Fig. I)

The height of cut is adjusted by the central cut height

adjustlever.

NOTE: If you are not sure which height to cut, begin mowing

with the cut height adjustment lever

10

positioned towards

the rear of the appliance and adjust the height down as needed,

as shown in Fig.I.

To Set the Height of Cut

1. Pull the cut height adjustment lever

10

out of the locking

notch

17

2. Move the lever towards the rear of the appliance to raise the

height ofcut.

3. Move the lever towards the front of the appliance to lower

the height ofcut.

4. Push the height adjustment lever into one of the

lockingnotches.

Safety Key (Fig. J)



DANGER: Sharp moving blade. In order to prevent

accidental start-up or unauthorised use of your

Cordless Mower, a removable safety key

3

has been

incorporated into the design of your mower. The mower

will be completely disabled when the safety key has been

removed from themower.

NOTE: The safety key has a rope attached to allow for

storage on a nail, out of the reach of children. do not

tether safety key tomower.



DANGER: Rotating blades can cause serious injury.

To prevent serious injury, remove safety key and

battery packs when unattended, or when charging,

cleaning, servicing, transporting, lifting, or

storingmower.

Starting Mower (Fig. K, L)



DANGER: Sharp moving blade. Never attempt to

override the operation of this switch box and safety

key system as serious injury couldresult.

NOTE: Mower is operational when batteries and safety key

areinstalled.

1. Insert safety key

3

into the ON-OFF switch box

1

until it is

fully seated inside housing as shown in Fig. K. The mower is

nowoperational.

2. Your mower is equipped with a special ON-OFF switch

box

1

. To operate the mower, push and hold the ON-OFF

button

2

on the ON-OFF switch box

1

, then pull the bail

handle

5

to the handlebar as shown in Fig.L. Once the

mower starts you can release theON-OFF button.

3. To turn the mower OFF, release the bailhandle

5



WARNING: Never attempt to lock a switch or bail handle

in the ONposition.

NOTE: Once the bail handle has returned to the original

position it will activate the “Automatic Braking Mechanism”. The

motor is mechanically braked and the mower blade will stop

rotating in three seconds orless.

Mower Overload

To prevent damage due to overload conditions, do not try to

remove too much grass at one time. Slow down your cutting

pace, or raise the cutheight.

Storage (Fig. A, M)



DANGER: Rotating blade can cause serious injury. Release

bail handle

5

to turn mower off, remove safety key, and

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of DeWalt DCMW564 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 21,27 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

DeWalt DCMW564 Manual

Product: