798207
10
Zoom out
Zoom in
Previous page
1/20
Next page
10
2.3 Placing roof sensors
Placing roof sensors in appropriate spots is very important to the performance of the Ice & Snow
melting system. The appropriate spot must fulfil some requirements, where the below 2 are the
most important:
The sensors must be placed minimum 1 meter within the boundaries of the heated zone
The sensors must not be covered and prevented from being exposed to snow or rain.
This includes dirt and especially leaves in the gutters.
2.3.1 Placing the first roof sensor in a zone
Find one who knows the area and make him describe the area function and weather conditions.
The first roof sensor in a zone must now be placed where ice and snow cause most problems.
The appropriate spot can be found by following below steps.
a) Where the heated area is in shade or oriented to the north/west
b) In the main gutter close to the main down pipe
If you have a dual zone system, the first sensor for the other zone must be placed by following
the same steps above.
2.3.2 Placing the following roof sensors in a zone
The following roof sensors in a zone must be placed where the surface dries up latest .
The appropriate spot can be found by following below steps.
c) Where the snow slides e.g. due to roof joints or gutter valleys
d) In other gutters, close to other down pipes
e) So the whole zone is covered, but min. 1 meter from other sensors
If there is doubt about the appropriate spot, prepare a second spot for later use.
2.3.3 Guiding plates
If a roof area is oriented to the south and the roof slope is
steep it can be exposed to strong sun radiation.
In that case it can be necessary to install guiding plates
above the sensor, so the slowly dripping melting water from
the roof hit the roof sensor.
If there is doubt about the appropriate spot, prepare a
second spot for later use.
2 Placing and installation of sensors
guiding plate
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Devi DEVIreg 850 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Devi DEVIreg 850 in the language / languages: English as an attachment in your email.

The manual is 0.48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Devi DEVIreg 850

Devi DEVIreg 850 User Manual - English - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info