498717
37
Zoom out
Zoom in
Previous page
1/96
Next page
ENGLISH
37
Cautions on Installation Active subwoofer (DSW-3L)
Other Cautions Active subwoofer (DSW-3L)
2 Note that placing the active subwoofer on the same stand or shelf as a record player may result in howling.
2 The DSW-3L active subwoofer is a Lowleakage-Flux type speaker system and can be used near televisions,
but depending on the TV there may be color blotching on the picture. If this happens, turn off the TVs power,
move the TV and subwoofer a little apart, wait 15 to 30 minutes, then turn the TVs power back on. The TVs
automatic degaussing circuit should reduce the blotching on the picture. If blotching persists, move the
subwoofer and TV further away from each other.
2 Install on a firm, flat floor to prevent accidents due to toppling down.
2 Do not place a record player, CD player or other AV device on top of the subwoofer.
2 The built-in amplifier of the active subwoofer (DSW-3L) includes a muting circuit. The output signal is strongly
attenuated for several seconds after the power is turned on. If the volume is adjusted during this time, the
output may be extremely high when the muting circuit is deactivated. Be sure to wait for the muting circuit
to be deactivated before adjusting the volume.
2 Note that color blotching may occur on a TV, etc., due to interaction with the subwoofer if there is a magnet
or an object generating magnetic force nearby.
Examples: (a) When there are magnets on the door of the rack, stand, etc.
(b) When a health device, etc., equipped with magnets is placed nearby.
(c) When toys or other objects using magnets are placed nearby.
2 Note that the illustrations in this instructions may differ from the actual set for explanation purposes.
2 Be sure to keep the operating instructions.
After reading these operating instructions, store them in a safe place. We also recommend filling in the
necessary items on the back cover.
WARNING:
Be sure to fasten the power cord to a wall, etc., to prevent people from tripping over it or otherwise pulling
on it accidentally, causing the subwoofer to fall.
Other Cautions (SC-A3L, SC-C3L)
2 Note that color blotching may occur on a TV, etc., due to interaction with the speaker system if there is a
magnet or an object generating magnetic force nearby.
Examples: (a) When there are magnets on the door of the rack, stand, etc.
(b) When a health device, etc., equipped with magnets is placed nearby.
(c) When toys or other objects using magnets are placed nearby.
2 Note that the illustrations in this instructions may differ from the actual set for explanation purposes.
2 Be sure to keep the operating instructions.
After reading these operating instructions, store them in a safe place. We also recommend filling in the
necessary items on the back cover.
PART NAMES AND FUNCTIONS
LINE IN
PHASE LF DIRECT
CROSSOVER(Hz)
REV. NORM.
AUTO STANDBY
ON
ON:GREEN
STANDBY:RED
OFFON
50
ON
POWER
OFF
OFF
200
LEVEL
MIN MAX
LINE OUT
q
w
e
r
t
y
u
i
o
q
Line input connector (LINE IN)
Connect this to the AV amplifiers pre-out
connector (SUBWOOFER, MONO OUT,
etc.) using the included connection cord (3-
meter RCA pin cord).
w
Line output connector (LINE OUT)
The signal input to the line input connector is
output as such from here in parallel.
When using two active subwoofers, connect
the other active subwoofers line input
connector to this connector.
e
Phase selector switch (PHASE)
This switches the phase of the output signal
with respect to the input signal.
Normally use the subwoofer with this switch
set at the NORM. position. If the continuity
between the sound of the active subwoofer
and the left and right speakers seems
unnatural, try switching to the REV.
position, and set the switch to the position in
which the sound is most natural.
Active subwoofer (DSW-3L) rear panel
r
LF direct switch (LF DIRECT)
When using the active subwoofer connected
to a Dolby Digital- or dts-compatible AV
amplifier, if this function is turned on the
signals bypass the active subwoofers
crossover and volume adjustment circuits,
resulting in purer, higher quality sound. Note
that when this is done the crossover
adjustment control (
t
) and volume
adjustment control (
y
) will no longer function.
When using in combination with the AVR-550SD,
we recommend turning the LF DIRECT switch on
and setting the AVR-550SDs crossover frequency
to 150 Hz.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon AVR-550SD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon AVR-550SD in the language / languages: German as an attachment in your email.

The manual is 10,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info