Manual Denon AVR-550SD (page 36 of 96) (German)

498717

Zoom out

Zoom in

1/96

ENGLISH

NOTES:

• If step 3 does not work, start over from step 1.

• If the microprocessor has been reset, all the button settings are reset to the default values (the values set

upon shipment from the factory).

INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable

result, the initialization of the microprocessor is required by the following procedure.

Press the power button to set the standby

mode, then unplug the set’s power cord from

the wall power outlet.

Hold the following 5CH/6CH STEREO button

and DIRECT/STEREO button after 30 second,

and plug the AC cord into the outlet.

Check that the entire display is flashing with an

interval of about 1 second, and release your

fingers from the 2 buttons and the

microprocessor will be initialized.

LAST FUNCTION MEMORY

• This unit is equipped with a last function memory which stores the input and output setting conditions as they

were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

• The unit is also equipped with a back-up memory. This function provides approximately one week of memory

storage when the main unit’s power switch is off and with the power cord disconnected.

USING THE SYS-550SD (DHT-550SD ONLY)

CAUTIONS ON HANDLING

When installing, carefully examine the place and method of installation for safety.

When using a stand, brackets, etc., follow the instructions included with the stand or brackets and check for

safety before installing and using. Denon will accept no responsibility for damages or accidents caused by the

unit falling.

Cautions on Installation – Speaker System (SC-A3L, SC-C3L)

The quality of the sound produced from the

speaker system is affected by the size and type

(Japanese or Western) of the room, as well as by

the method of installation. Consider the points

listed below before installing the speaker system.

2 Note that placing the speaker system on the same

stand or shelf as a record player may result in

howling.

2 If there is a wall, glass door, etc., directly in front of

or behind the speaker system, cover the wall or

door with a thick curtain to prevent resonance and

reflection.

2 The SC-A3L and SC-C3L speaker systems are of

the low-leakage-flux type and can be used near

televisions, but depending on the TV there may be

color blotching on the picture. If this happens, turn

off the TV’s power, wait 15 to 30 minutes, then

turn the TV’s power back on. The TV’s automatic

degaussing circuit should reduce the blotching on

the picture. If blotching persists, move the speaker

further away.

2 The center speaker (SC-C3L) is equipped with anti-

slip pads upon shipment from the factory. If

necessary, however, also apply the included anti-

slip pads (cork, approximately 2 mm thick).

When placing the satellite speaker system (SC-A3L)

on a stand, etc., stick the included anti-slip pads

(cork, approximately 2 mm thick) at the four corners

of the bottom surface. (Refer to the illustration

below.)

[

Satellite speaker system (illustration of bottom of SC-A3L)

]

Stick the anti-slip pads (cork, approximately 2 mm

thick) here.

Stick the anti-slip pads (cork, approximately 2 mm

thick) here.

Speaker

stand/speaker

bracket mount

screw holes

CAUTION:

• To ensure safety, do not place any objects on

top or lean objects against the speaker system.

• The speaker may topple down or fall if force is

applied to the sides. Be particularly careful to

avoid this, as this could cause injury or other

serious accidents.

WARNING:

• When installing the speaker systems on the

ceiling or wall, to ensure safety, have specialists

do the installation work.

• Be sure to fasten the speaker cords to a wall,

etc., to prevent people from tripping over them

or otherwise pulling on them accidentally,

causing the speaker systems to fall.

• Be sure to check for safety after installing the

speaker systems. Afterwards, perform safety

inspections at regular intervals to be sure there

is no danger that the speaker systems will fall.

Denon will accept no responsibility for damages

or accidents caused by inappropriate choice of

the place of installation or improper installation

procedures.

2 When mounting the satellite speaker system (SC-

A3L) on a stand or bracket, M5 nuts are inserted

into the bottom of the satellite speaker system

(SC-A3L) at intervals of 60 mm. When mounting,

following the instructions in the manual included

with the speaker stand or ceiling mount bracket,

and be sure to install properly and securely.

2 When the satellite speaker system (SC-A3L) is

mounted on a ceiling mount bracket, it is turned

upside down due to the installation angle. The

Denon mark is also turned upside down, so detach

the speaker net and reattach it in the opposite

direction.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Denon AVR-550SD in the language / languages: German as an attachment in your email.

The manual is 10,07 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Denon AVR-550SD Manual

Product: