498717
20
Zoom out
Zoom in
Previous page
1/96
Next page
20
ENGLISH
3
Select the play mode.
Press the SURROUND MODE button, then turn
the SELECT knob.
The volume can be adjusted within the
range of 70 to 0 to 18 dB, in steps of 1 dB.
However, when the channel level is set as
described on page 23, if the volume for any
channel is set at +1 dB or greater, the
volume cannot be adjusted up to 18 dB. (In
this case the maximum volume is adjusted
to 18 dB (Maximum value of channel
level).)
Input mode when playing DTS sources
Noise will be output if DTS-compatible CDs or LDs
are played in the ANALOG or PCM mode.
When playing DTS-compatible sources, be sure to
connect the source component to the digital input
jacks (OPTICAL/COAXIAL) and set the input mode to
DTS.
4
Start playback on the selected component.
For operating instructions, refer to the
components manual.
5
Adjust the volume.
MASTER VOLUME
(Main unit)
(Remote control
unit)
The volume level
is displayed on
the master
volume level
display.
To select the surround mode
while adjusting the surround
parameters, tone defeat or
tone control, press the
surround mode button then
operate the selector.
SURROUND MODE
(Main unit) (Remote control unit)
FUNCTION / SELECT
Input mode display
In the AUTO mode
In the DIGITAL PCM mode
In the DIGITAL DTS mode
In the ANALOG mode
One of these lights,
depending on the input
signal.
Input signal display
DOLBY DIGITAL
DTS
PCM
The indicator lights when digital signals are
being input properly. If the indicator does not
light, check whether the digital input component
setup (page 14) and connections are correct and
whether the components power is turned on.
DIG
DIG
NOTE:
The indicator will light when playing CD-
ROMs containing data other than audio signals,
but no sound will be heard.
DIG
NOTE:
Note that noise will be output when CDs or LDs
recorded in DTS format are played in the PCM
(exclusive PCM signal playback) or ANALOG
(exclusive PCM signal playback) mode. Select the
AUTO or DTS mode when playing signals recorded
in DTS.
Notes on playing a source encoded with DTS
Noise may be generated at the beginning of
playback and while searching during DTS
playback in the AUTO mode. If so, play in the
DTS mode.
In some rare cases the noise may be generated
when you preform the operation to stop
playback of a DTS-CD or DTS-LD.
Example: Stereo
(Main unit)
Playback using the external input (EXT. IN) jacks
(Remote control unit)
1
Set the external input (EXT. IN) mode.
Press the EXT. IN to switch the external input.
2
Cancelling the external input mode
To cancel the external input (EXT. IN) setting,
press the INPUT MODE (AUTO, PCM, DTS) or
ANALOG button to switch to the desired input
mode. (See page 19.)
(Remote control unit)
Once this is selected, the input signals
connected to the FL (front left), FR (front right),
C (center), SL (surround left), and SR (surround
right) channels of the EXT. IN jacks are output
directly to the front (left and right), center,
surround (left and right) speaker systems
without passing through the surround circuitry.
In addition, the signal input to the SW
(subwoofer) jack is output to the PRE OUT
SUBWOOFER jack.
When the input mode is set to the external input
(EXT. IN), the play mode (DIRECT, STEREO,
DOLBY/DTS SURROUND, 5CH/6CH STEREO,
VIRTUAL SURROUND (DOLBY VIRTUAL SPEAKER)
or DSP SIMULATION) cannot be selected.
2
1
NOTES:
In play modes other than the external input
mode, the signals connected to C, SL, SR and
SW jacks cannot be played. In addition, signals
cannot be output from channels not connected
to the input jacks.
The external input mode can be set for any input
source. To watch video while listening to sound,
select the input source to which the video signal
is connected, then set this mode.
One of these lights,
depending on the input
signal.
SURROUND MODE
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon AVR-550SD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon AVR-550SD in the language / languages: German as an attachment in your email.

The manual is 10,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info