power supply.
Never immerse the coffee maker in water.
Cleaning the inside of the coffee
maker
1. Check regularly (about once a week) that the
inside of the appliance is not dirty. If neces-
sary, remove coffee deposits with a knife and
a sponge.
2. Remove the residues with a vacuum cleaner
(fig. 29).
Cleaning the infuser
The infuser must be cleaned at least once a
month.
Important!
The infuser (A8) must not be
removed when the appliance is on. Do not attempt
to use force to remove the infuser as this could
damage the coffee maker.
1. Make sure the machine is correctly turned off
(see "Turning the appliance off").
2. Open the service door (fig. 25);
3. Remove the drip tray and grounds container
(fig. 26);
4. Press the two red release buttons inwards and
at the same time pull the infuser outwards
(fig. 30).
Important!
Do not use washing up liquid to
clean the infuser. The detergent would remove the
lubricant applied to the inside of the piston, cau-
sing the infuser to seize up and become unusable.
5. Soak the infuser in water for about 5 minutes,
then rinse under the tap.
6. After cleaning, replace the infuser by sliding it
onto the internal support and pin at the bot-
tom, then push the PUSH symbol fully in until
it clicks into place.
NB!
If the infuser is
difficult to insert, you must
first adapt it to the right
dimension by pressing it
forcefully from the bottom
and top as shown in the
figure.
7. Once inserted, make
sure the two red but-
tons have snapped out.
8. Replace the drip tray
and grounds container.
9. Close the service door.
Cleaning the milk container
Clean the milk container each time you prepare
milk as described below:
1. Turn the milk con-
tainer lid clockwise
then remove it.
2. Remove the milk
spout and intake
tube.
3. Remove the fro-
thed milk regulator
by pulling it out-
wards.
4. Wash all the com-
ponents tho-
roughly with hot
water and mild
washing-up liquid.
All components
can be washed in a
dishwasher, pla-
cing them in the
top basket of the
dishwasher.
Make sure there
are no milk resi-
dues left inside the
holes and the
groove on the fine end of the frothed milk
regulator.
5. Check that the intake tube and spout are not
clogged with milk residues.
6. Replace the frothed milk regulator, milk spout
and intake tube.
7. Replace the lid on the milk container, turning
it anticlockwise to hook it in place.
pin
support
36
spout
milk intake
tube
groove
frothed milk regulator
hole
hole
