788660
4
Zoom out
Zoom in
Previous page
1/12
Next page
9
• The appliance could be damaged if the water inside it
freezes�
Do not install the appliance in a room where the
temperature could drop below freezing point
• The appliance gives o heat�
After positioning the appliance on the worktop, leave
a space of at least 3 cm between the surfaces of the
appliance and the side and rear walls and at least 15 cm
above the coee machine�
• Water penetrating the appliance could cause damage�
Do not place the appliance near taps or sinks�
• Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces
(e�g� electrical hot plates)�
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance
Connecttheappliancetoanecientlyearthedandcorrectly
installed socket with a minimum current rating of 10A only
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional
Setting up the appliance
Please note:
• Coeehasbeenusedtofactorytesttheapplianceandit
is therefore completely normal for there to be traces of
coee in the grinder
The machine is, however, guaranteed to be new
• Youshouldcustomisewaterhardnessassoonaspossible
following the instructions in the section “Setting water
hardness” on page 15)�
Follow these instructions:
1� Remove the water tank, ll to the MAX line with fresh
water (g1A) then insert back into the appliance (g�
1B)�
2� Place a container with a minimum capacity of 100 ml
under the cappuccino maker (g� 2)�
3�
Insert the power cable connector into the socket at the
back of the appliance and connect the appliance to the
mains electricity supply (g� 3)� Make sure the main power
switchat the back of the appliance is pressed down (g�
4)�
4� The indicator should ash on the control panel (g�
5)�
5� Turn the steam dial to the “I” position (g� 6)� Water is
delivered by the cappuccino maker, then the appliance
switches itself o
6� Turn the steam dial to the “0” position�
The coee machine is now ready for normal use�
Please note:
• When setting up the appliance, you need to make 4-5
cups of coee or 4-5 cappuccinos before the appliance
starts to give satisfactory results�
TURNING THE APPLIANCE ON
Please note:
• Before turning the appliance on, make sure the main
power switch at the back of the appliance is pressed down
(g� 4)�
• Each time the appliance is turned on, it performs an
automatic preheat and rinse cycle which cannot be
interrupted� The appliance is ready for use only once this
cycle is complete�
Danger of scalding!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath�
Avoid contact with splashes of water
• Toturntheapplianceon,pressthe button (g� 7):
the indicator ashes while the appliance is heating up
and performing the automatic rinse cycle� By circulating
hot water, the appliance heats both the boiler and the
internal circuits�
The appliance as reached the correct temperature once all the
indicators on the buttons are on - indicating that any function
can now be selected�
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted
Danger of scalding!
During rinsing, a little hot water comes out of the coee
spouts�
Avoid contact with splashes of water
To turn the appliance o, press the button (g� 7)�
The appliance performs a rinse cycle then turns o (stand-by)�
Please note:
If you will not be using the appliance for some time, unplug it
from the mains socket:
• rstturntheapplianceobypressingthe button
(g.7);
• pressthemainpowerswitch(g.4).
Important!
Never press the main power switch while the appliance is
switched on�
4


Need help? Post your question in this forum.

Forumrules
1

Forum

delonghi-ecam-13.123

Reset search

  • Dear customer service,

    My DeLonge coffee machine repeatedly displays the same error when I select ground coffee. Despite following these troubleshooting steps, the issue remains (the coffee container light flashes, and the danger signal is on):

    1. **Check the Coffee Grounds**
    2. **Clean the Machine**
    3. **Check the Water Supply**
    4. **Reset the Machine**
    5. **Check for Blockages**
    6. **Consult the Manual** Submitted on 8-9-2024 at 11:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ECAM 13.123 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECAM 13.123 in the language / languages: English as an attachment in your email.

The manual is 2.93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECAM 13.123

DeLonghi ECAM 13.123 User Manual - German - 13 pages

DeLonghi ECAM 13.123 User Manual - Dutch, Danish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish - 195 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info