788660
12
Zoom out
Zoom in
Previous page
1/12
Next page
17
INDICATOR DISPLAYED POSSIBLE CAUSE SOLUTION
FLASHING
The infuser has not been properly replaced
after cleaning�
Insert the infuser as described in the section “Cleaning
the infuser”
The inside of the appliance is very dirty� Clean the inside of the appliance thoroughly, as described
in the section “Cleaning and maintenance” If the message is
still displayed after cleaning, contact a service centre�
TROUBLESHOOTING
Below is a list of some of the possible malfunctions�
If the problem cannot be resolved as described, contact a Service Centre�
PROBLEM POSSIBLE CAUSE SOLUTION
The coee is not hot The cups were not preheated� Warm the cups by rinsing them with hot water� The hot
water or rinse function can be selected�
The infuser has cooled down because 2/3 minutes have
elapsed since the last coee was made�
Before making coee, heat up the infuser by pressing the
rinse button�
The coee is weak or not
enough crema�
The coee is ground too coarsely Turn the grind coarseness dial one click anticlockwise while
the grinder is in operation (g� 14)�
Continue one click at a time until coee delivery is
satisfactory�
The eect is only visible after 2 coees have been made
(see the section Adjusting the grinder” on page 11)�
Dierent blends of coee can also aect this� Try a dierent blend of coee�
The coee is delivered too
slowly or in drops
The coee is ground too nely
Even if large bubbles are present it is recommended to
knock the large bubbles out by gently tapping the milk
container against a hard surface and swirling the milk
around�
Turn the grinding dial one click clockwise while the grinder
is in operation (g� 14)�
Continue one click at a time until coee delivery is
satisfactory�
The eect is only visible after 2 coees have been made
(see the section Adjusting the grinder” on page 11)�
Coee does not come out of
one or both spouts�
The spouts are blocked� Clean the spouts with a toothpick�
The frothed milk has large
bubbles
The milk is not cold enough or is not semi-skimmed You should ideally use skimmed or semi-skimmed milk at
refrigerator temperature (about 5°C)�
If the result is not as you wished, try changing brand of
milk�
The milk is not frothed Cappuccino maker is dirty� Clean as described in the section “Cleaning the cappuccino
maker after use (page 13)�
Steam delivery stops A safety device stops steam delivery after 3 minutes� Wait, and then enable the steam function again�
The appliance does not turn
on�
It is not plugged into the mains socket Plug into the mains socket
The main power switch (A8) is not turned on� Push the main power switch (g� 4)�
12


Need help? Post your question in this forum.

Forumrules
1

Forum

delonghi-ecam-13.123

Reset search

  • Dear customer service,

    My DeLonge coffee machine repeatedly displays the same error when I select ground coffee. Despite following these troubleshooting steps, the issue remains (the coffee container light flashes, and the danger signal is on):

    1. **Check the Coffee Grounds**
    2. **Clean the Machine**
    3. **Check the Water Supply**
    4. **Reset the Machine**
    5. **Check for Blockages**
    6. **Consult the Manual** Submitted on 8-9-2024 at 11:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ECAM 13.123 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECAM 13.123 in the language / languages: English as an attachment in your email.

The manual is 2.93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECAM 13.123

DeLonghi ECAM 13.123 User Manual - German - 13 pages

DeLonghi ECAM 13.123 User Manual - Dutch, Danish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish - 195 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info